Indesit DVG 622 Manuale di installazione e uso - Pagina 8
Sfoglia online o scarica il pdf Manuale di installazione e uso per Lavastoviglie Indesit DVG 622. Indesit DVG 622 17. Indesit dishwasher installation and use
Anche per Indesit DVG 622: Istruzioni per l'uso (3 pagine), Manuale (21 pagine)
Stampa la pagina
Turning on the Appliance
First of all.
Turn on the water tap completey and press ON-OFF button
"A" and the indicator light "B" goes on.
Now the appliance is on and awaiting instructions.
Starting and selecting the cycle.
Turn the cycle selector knob "D" clockwise until the reference
notch on the knob corresponds with the number or symbol
for the cycle you wish to set (consult the wash cycle table on
page 7, especially when first using the appliance).
If the appliance door is shut, press the Start button "R" and
the cycle will start up within a few seconds.
Cycle phase indicator lights
The dishwasher is provided with 4 indicator lights "G" which
come on in sequence as the appliance is performing that
specific phase of the wash cycle.
These phases are:
pre-wash,
wash,
Cancelling or modifying a wash cycle in progress.....
Premise: You can cancel the wash cycle in progress, if it has
only just started.
To modify a wash cycle, keep the RESET button "R" pressed
for about 5 seconds: Indicator light "G" will turn off and at
this point, all the settings will have been cancelled.
To select a new wash cycle, repeat the operations illustrated
in the paragraph entitled "starting and selecting the cycle".
Warning: the knob must be turned clockwise from wash
cycle 1 to 5, an anti-clockwise from wash cycle 5 to 1.
If you have left out a dish...
You can interrupt a wash cycle by pressing the ON-OFF
button, then place the dishes you had left out into the
appliance, which will start up from where it was interrupted
when you turn it back on.
GB
rinses,
drying
There's been a power failure? Have you opened the
dishwasher door?
The wash cycle stops and then restarts when the electricity
comes back on or when the door is shut.
At the end of the wash cycle....
The end of the wash cycle is indicated by the flashing of the
drying phase indicator light.
Warning:
Turn the appliance off by pressing button "A", unplug
the appliance from the electricity socket to cut off the
power supply; the power supply cable should
consequently be easily accessible.
• Turn off the water tap.
• Wait a few minutes before unloading the dishes: if you
wait a little while, they dry better thanks to the steam.
• Empty the lower rack first.
Warning: when you open the dishwasher door after the wash
cycle has just ended or is under way, take care not to scald
yourself with the hot steam.
6