Indesit mm10k Manuale di istruzioni per l'uso - Pagina 3

Sfoglia online o scarica il pdf Manuale di istruzioni per l'uso per Forno Indesit mm10k. Indesit mm10k 11.

Stampa la pagina

Electrical Connection

Those ovens equipped with a three-pole power supply

cable are designed to operate with an alternating

current with the voltage and frequency indicated on

the data plate (located on the appliance) and in the

instruction manual. The wire for earthing the

appliance is yellow-green in colour.

Replacing the cable

Use a rubber cable of the type H05VV-F with a

suitable cross section 3 x 1.5 mm².

The yellow-green earth wire must be 2-3 cm longer

than the other wires.

Opening the terminal board:

•

Using a screwdriver, prise on the side tabs of the

terminal board cover;

•

Pull open the cover of the terminal board.

To install the cable, proceed as follows:

•

Remove the wire clamp screw and the three

contact screws L-N-

•

Fasten the wires beneath the screwheads using

the following colour scheme: Blue (N) Brown (L)

Yellow-Green

•

Fasten the supply cable in place with the clamp

and close the cover of the terminal board.

Connecting the supply cable to the mains

Install a standardised plug corresponding to the load

indicated on the data plate. When connecting the

cable directly to the mains, install an omnipolar

circuit-breaker with a minimum contact opening of 3

mm between the appliance and the mains. The

omnipolar circuit breaker should be sized according

to the load and should comply with current regula-

tions (the earth wire should not be interrupted by the

circuit breaker).

The supply cable should be positioned so that it does

not reach a temperature of more than 50°C with

respect to the room temperature, anywhere along its

length.

Before making the connection, check that:

•

The electrical safety of this appliance can only be

guaranteed if the cooker is correctly and

efficiently earthed, in compliance with regulations

on electrical safety. Always ensure that the

earthing is efficient; if you have any doubts call in

a qualified technician to check the system. The

manufacturer declines all responsibility for

damage resulting from a system which has not

been earthed.

•

Before plugging the appliance into the mains,

check that the specifications indicated on the

date plate (on the appliance and/or packaging)

correspond to those of the electrical mains

system of your home.

•

Check that the electrical capacity of the system

and sockets will support the maximum power of

the appliance, as indicated on the data plate. If

you have any doubts, call in a qualified

technician.

•

If the socket and appliance plug are not

compatible, have the socket replaced with a

suitable model by a qualified technician. The

latter, in particular, will also have to ensure that

the cross section of the socket cables are suit-

able for the power absorbed by the appliance. The

use of adapters, multiple sockets and/or

extensions, is not recommended. If their use

cannot be avoided, remember to use only single

or multiple adapters and extensions which comply

with current safety regulations. In these cases,

never exceed the maximum current capacity

indicated on the single adapter or extension and

the maximum power indicated on the multiple

adapter.

The plug and socket must be easily accessible.