Indesit K6M52/EO Manuale di installazione e uso - Pagina 4

Sfoglia online o scarica il pdf Manuale di installazione e uso per Fornelli Indesit K6M52/EO. Indesit K6M52/EO 36. Cooker with electric multifunction oven

Stampa la pagina

The following instructions should be read by a qualified

technician to ensure that the appliance is installed, regu-

lated and technically serviced correctly in compliance with

current regulations.

Important: Disconnect the appliance from the electri-

cal supply before performing any maintenance or

regulating the appliance.

Positioning

Important: This unit may be installed and used only in

permanently ventilated rooms in accordance with current

National Regulations. The following requirements must be

observed:

a) The room must be equipped with an exhaust system

that vents the combustion fumes to the outside. It may

consist of a hood or an electric fan that automatically

starts each time the appliance is turned on.

A Flue or Branched Flue System

(only for cooking appliances)

b) The room must also have a system to permit proper air

circulation, needed for combustion to occur normally. The

flow of air needed for combustion must not be less than

2 m

/h per kW of installed power. The air circulation sys-

tem may take air directly from the outside by means of a

pipe with an inner cross section of at least 100 cm

opening must not be able to be accidentally blocked. For

those appliances not equipped with a safety device for

accidental flame loss, the ventilation apertures must be

increased by 100%, with the minimum being 200cm

(Fig. A). The system can also provide the air needed for

combustion by indirect means, i.e. from adjacent rooms

fitted with air circulation tubes as described above. How-

ever, these rooms must not be common rooms or bed-

rooms. (Fig. B).

Detail A

Examples of Ventilation

Openings Comburent Air

Fig. A

c) Intensive and prolonged use of the appliance may re-

sult in the need for supplemental air circulation, e.g.

Installation

Directly to the outside

; the

Adjacent

Room to be

Room

Ventilated

Increased Opening Between

Door and Floor

Fig. B

opening windows or increasing mechanical venting (if

present).

d) Liquified petroleum gas is heavier than the air and,

therefore, settles downwards. Thus, rooms containing

LPG cylinders must also be equipped with apertures

to the outside for ventilation of gas in the case of leaks.

LPG cylinders must not, therefore, be installed or stored

in rooms or storage areas that are below ground level

(cellars, etc.) whether they are partially or completely

full. It is a good idea to keep only the cylinder being

used in the room, positioned so that it is not subject to

heat produced by external sources (ovens, fireplaces,

stoves, etc. ) which are able to increase the tempera-

ture of the cylinder above 50°C.

Levelling your Appliance (only on certain models)

4 support feet which are adjusted using screws are located

in the lower part of the cooker. These level off the oven

when necessary. It is essential that the cooker be standing

level.

Mounting the Legs (only on certain models)

Legs are provided and can be installed under the base of

the cooker.

Installation of the Cooker

The appliance can be installed next to furniture units which

are no taller than the top of the cooker hob. The wall in

direct contact with the back panel of the cooker must be

made of non-flammable material. During operation the

back panel of the cooker could reach a temperature of

50°C above room temperature. For proper installation of

the cooker, the following precautions must be taken:

a) Kitchen cabinets installed next to the cooker that are

higher than the top of the hob, must be at least 600 mm

from the edge of the hob itself.

b) Hoods must be installed according to the requirements

in the installation manual for the hood and, in any case,

at a minimum height of 650 mm.

c) If the hood is installed below a wall cabinet, the latter

must be at least 700 mm (millimetres) above the surface

of the hob. Cabinets installed adjacent to the hood must

be at least 420 mm above the hob, as shown in Figures