Indesit KD3G2/G Manuale di istruzioni per l'installazione e l'uso - Pagina 5

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione e l'uso per Fornelli Indesit KD3G2/G. Indesit KD3G2/G 24. 50cm free standing gas cooker
Anche per Indesit KD3G2/G: Manuale di istruzioni per l'installazione e l'uso (24 pagine), Manuale di istruzioni per l'uso (25 pagine)

Gas connection

The cooker should be connected to the gas-supply by a corgi registered installer. During installation of this

product it is essential to fit an approved gas tap to isolate the supply from the appliance for the convenience

of any subsequent removal or servicing. Connection of the appliance to the gas mains or liquid gas must be

carried out according to the prescribed regulation in force, and only after it is ascertained that it is adaptable

to the type of gas to be used. If not, follow the instructions indicated in the paragraph headed "Adaptation to

different gas types". On some models the gas supply can be connected on the left or on the right, as

necessary; to change the connection, reverse the position of the hose holder with that of the cap and

replace the gasket (supplied with the appliance). In the case of connection to liquid gas, by tank, use

pressure regulators that conform to the regulation in force. The gas supply must be connected to the left of

the appliance. Be sure that the hose does not pass through the rear of the cooker touching hot parts.

Important: make sure the supply pressure conforms with the values shown in the table entitled "Caracteristics of

the burners and nozzles". When the cooker is installed between cabinets (recessed), the gas connection

must be effected by an approved flexible hose with bayonet fitting (BS 669 Current Edition). The gas inlet

for the cookers is a threaded G 1/2 gas female fitting.

Connecting the gas supply

To make the connection, a flexible hose should be used corresponding to the current gas regulations which are:

•

the hose must never be at any point in its lenght in contact with the "hot" parts of the cooker;

•

the hose must never be longer than 1,5 metre;

•

the hose must not be subject to any tension or torsional stress and it must not have any excessively narrow

curves or bottlenecks;

the hose must be easy to inspect along its entire length to check its condition;

•

the hose must always be in good condition, never attempt to repair.

Important: the installation must comply with gas safety (installation and use) regulations 1984. In all cases for the

above, by low, a qualified, corgi approved engineer must be called for installation.

Important: Before using the oven, position the oven burner deflector "A" (provided with the appliance) in the

correct place by inserting the lower tab into the support slot (see figure).

HOT PARTS