AEG SILENCETECH 9000 Manuale d'uso - Pagina 4

Sfoglia online o scarica il pdf Manuale d'uso per Cappa di ventilazione AEG SILENCETECH 9000. AEG SILENCETECH 9000 12.

• WARNING: Failure to install the screws or fixing device in

accordance with these instructions may result in electrical

hazards.

• Do not use adhesives to fix the appliance.

• The minimum distance between the hob surface on which

the pans stand and the lower part of the appliance shall be

at least 65 cm, unless otherwise specified in the installation

instructions for the appliance or hob.

• The discharge of air must comply with local authorities

regulations.

• Ensure good air ventilation in the room where the appliance

is installed to avoid the backflow of gases into the room

from appliances burning gas or other fuels, including open

fires.

• Make sure that the ventilation openings are not blocked and

the air collected by the appliance is not conveyed into a

duct used to exhaust smoke and steam from other

appliances (central heating systems, thermosiphons, water-

heaters, etc.).

• When the appliance operates with other appliances the

maximum vacuum generated in the room should not exceed

0.04 mbar.

• If the supply cord is damaged, it must be replaced by the

manufacturer, its Authorised Service Centre or similarly

qualified persons to avoid an electrical hazard.

• If the cord set is damaged, it must be replaced by a special

cord set available from the manufacturer or its Authorised

Service Centre.

• If the appliance is connected directly to the power supply,

the electrical installation must be equipped with an isolating

device that allows to disconnect the appliance from the

mains at all poles. Complete disconnection must comply

with conditions specified in the overvoltage category III. The

means for disconnection must be incorporated in the fixed

wiring in accordance with the wiring rules.

• Do not flambé under the appliance.

ENGLISH