Purge Mode
Your Kohler Bath with Airjets
Components
Your new bath with airjets is designed to stimulate, invigorate, and energize your body with soothing
massage therapy. It can also provide a gentle relaxing massage when operated at a lower speed.
• Bath - Allows the bather to relax in comfort while enjoying the air massage.
• Blower Motor - Provides quiet power to supply air for a soothing massage action.
• Airjets - Distributes and releases the air at the lower edge of the bath side and end walls for a
soothing massage action.
• User Keypad - Located within easy reach, the user keypad turns the unit on and off, controls the air
flow rate, and controls the manual purge mode.
User Keypad
On/Off - Turns the blower motor on or off. Press the button once to start the blower motor at a
mid-range speed. Press the button again to stop the blower motor. The blower motor automatically
stops after about 20 minutes of operation.
NOTE: An automatic purge cycle will initiate approximately 30 minutes after the blower motor has
stopped. To activate the purge cycle sooner, manually initiate the purge mode.
Purge Mode - Initiates a manual purge cycle, which will blow any residual water out of the air
channels after the bath has been drained. Press the button once to start the blower motor at low
speed. The blower motor stops automatically after about two minutes. Press the button again before
the cycle ends to stop the blower motor.
Up Arrow - Increases the air flow.
Down Arrow - Decreases the air flow.
Operation
Close the drain, then fill the bath to a level at least 4" (10 cm) above the top of the highest airjets.
Use your hand to test the water temperature for comfort and safety, then carefully enter the basin.
Press the On/Off button to turn on the blower motor.
NOTE: For baths equipped with an optional timer: Approximately 20 minutes of continuous operation,
the blower motor will stop. If desired, press the On/Off button to restart the blower motor.
If desired, press the up or down arrow buttons to change the air flow rate.
When finished bathing, press the power button a second time to turn off the blower motor.
Carefully exit the bath, then open the drain to empty the bath.
1034591-5-K
On/Off
4
Increases Flow
Decreases Flow
Kohler Co.
Stampa la pagina