Kohler K-1112 Manuale di installazione - Pagina 5

Sfoglia online o scarica il pdf Manuale di installazione per Vasche da bagno Kohler K-1112. Kohler K-1112 48. Bath with airjets
Anche per Kohler K-1112: Manuale del proprietario di casa (32 pagine), Manuale del proprietario di casa (29 pagine), Manuale (4 pagine), Manuale del proprietario di casa (36 pagine), Manuale di installazione (44 pagine), Manuale di messa a punto (4 pagine), Manuale di installazione (48 pagine), Manuale di installazione (44 pagine), Manuale del proprietario di casa (29 pagine)

1. Prepare the Site

NOTICE: Do not support the bath by the rim.

NOTICE: Refer to the Roughing-in Guide packed with this product for proper minimum lbs/square foot

(kg/square meter) ﬂoor support loading.

NOTICE: Provide adequate ventilation and a minimum of 15 cubic feet (.4 cubic meters) in the installed

location for cooling the motor and to supply sufficient air for the blower. Do not install the blower motor

closer than 1" (2.5 cm) from the wall or other objects.

Make sure the ﬂoor offers adequate support for your bath, and verify that the subﬂoor is ﬂat and

level.

This bath may be installed in a drop-in or island installation. An island installation requires a four

side surround.

Construct 2x4 or 2x6 stud framing designed for your particular installation.

Provide for a 1/16" (2 mm) gap between the bottom of the bath rim and the stud framing. Frame

the ﬂoor, or construct a frame for a raised installation in accordance with the roughing-in

information packed with the bath with airjets.

For a drop-in installation, carefully lay out and cut the rough deck material. Use the cutout template

if one is provided, or refer to the roughing-in cutout information.

For an island installation, construct a 2x4 frame in accordance with the roughing-in information

packed with the bath with airjets.

Install an access panel to allow the blower motor to be serviced.

Position the plumbing according to the roughing-in information packed. Cap the supplies, and

check for leaks.

Kohler Co.

Position the

rough plumbing.

Construct 2x4 or

2x6 stud framing

according to the

roughing-in

information.

Provide a 1/16" (2 mm)

gap between the bath

rim and framing.

Frame the floor

according to the

roughing-in information.

Verify that the subfloor

offers adequate support,

and is flat and level.

1034591-2-F