Kohler COMMAND CV16 Manuale d'uso - Pagina 9

Sfoglia online o scarica il pdf Manuale d'uso per Motore Kohler COMMAND CV16. Kohler COMMAND CV16 17. Vertical crankshaft
Anche per Kohler COMMAND CV16: Manuale d'uso (16 pagine), Manuale d'uso (16 pagine)

Stampa la pagina

Operating

Range

Figure 7. Oil Level Dipstick.

5. If the level is low, add oil of the proper type, up to

the "F" mark on the dipstick. (Refer to "Oil Type"

on page 4.) Always check the level with the

dipstick before adding more oil.

NOTE: To prevent extensive engine wear or

damage, always maintain the proper oil

level in the crankcase. Never operate the

engine with the oil level below the "L"

mark or over the "F" mark on the dipstick.

Oil Sentry™

Some engines are equipped with an optional Oil

Sentry™ oil pressure switch. If the oil pressure

decreases below an acceptable level, the Oil Sentry™

will either shut off the engine or activate a warning

signal, depending on the application.

NOTE: Make sure the oil level is checked BEFORE

EACH USE and is maintained up to the "F"

mark on the dipstick. This includes engines

equipped with Oil Sentry™.

Change Oil and Oil Filter

Change Oil

Change oil after every 100 hours of operation. Refill

with service class SG, SH, SJ or higher oil as specified

in the "Viscosity Grades" table (Figure 2) on page 4.

Change the oil while the engine is still warm. The oil

will flow more freely and carry away more impurities.

Make sure the engine is level when filling, checking, or

changing the oil.

Change the oil as follows (see Figure 8):

1. To keep dirt, grass clippings, etc., out of the

"F" Mark

2. Remove the oil drain plug and oil fill cap/dipstick.

3. Reinstall the drain plug. Make sure it is tightened

4. Fill the crankcase, with new oil of the proper type,

5. Reinstall the oil fill cap or plug and tighten

Oil Drain Plug

(Carb. Side)

Optional Oil Sentry™ Switch

Figure 8. Oil Drain Plugs, Oil Filter, Oil Filter Drain

Plug, and Optional Oil Sentry™ Switch.

engine, clean the area around the oil fill cap/

dipstick before removing it.

Be sure to allow ample time for complete

drainage.

to 13.6 N·m (10 ft. lb.) torque.

to the "F" mark on the dipstick. Refer to "Oil Type"

on page 4. Always check the level with the dipstick

before adding more oil.

securely.

NOTE: To prevent extensive engine wear or

damage, always maintain the proper oil

level in the crankcase. Never operate the

engine with the oil level below the "L"

mark or over the "F" mark on the dipstick.

Oil Filter

Oil Drain Plug

(Starter Side)

Optional Oil

Filter Drain Plug