Kohler Command PRO CH26 Manuale d'uso - Pagina 8

Sfoglia online o scarica il pdf Manuale d'uso per Motore Kohler Command PRO CH26. Kohler Command PRO CH26 21. Command series
Anche per Kohler Command PRO CH26: Manuale d'uso (21 pagine), Manuale d'uso (21 pagine), Manuale d'uso (8 pagine), Manuale d'uso (21 pagine), Manuale d'uso (14 pagine)

Stampa la pagina

Stopping

1. Remove the load by disengaging all PTO driven

attachments.

2. For Carbureted Engines Without A Shutdown

Solenoid: Move the throttle to the slow or low

idle position. Allow the engine to run at idle for

30-60 seconds; then stop the engine.

For Carbureted Engines Equipped With A

Shutdown Solenoid: Position the throttle control

somewhere between half and full throttle; then

stop the engine.

For EFI Engines: Move the throttle to the slow or

idle position; turn key off to stop engine.

Battery

A 12 volt battery is normally used. Refer to the

operating instructions of the equipment this engine

powers for specific battery requirements.

If the battery charge is not sufficient to crank the

engine, recharge the battery (see page 13).

Operating

Angle of Operation

This engine will operate continuously at angles up to

25°. Check oil level to assure crankcase oil level is at

the "F" mark on the dipstick.

Refer to the operating instructions of the equipment

this engine powers. Because of equipment design or

application, there may be more stringent restrictions

regarding the angle of operation.

NOTE: Do not operate this engine continuously at

angles exceeding 25° in any direction. Engine

damage could result from insufficient

lubrication.

Cooling

NOTE: If debris builds up on the grass screen or

other cooling air intake areas, stop the engine

immediately and clean. Operating the engine

with blocked or dirty air intake and cooling

areas can cause extensive damage due to

overheating.

WARNING: Hot Parts!

Engine components can get extremely hot from operation. To

prevent severe burns, do not touch these areas while the engine

is running, or immediately after it is turned off. Never operate

the engine with heat shields or guards removed.

Engine Speed

NOTE: Do not tamper with the governor setting to

increase the maximum engine speed.

Overspeed is hazardous and will void the

engine warranty. The maximum allowable

high idle speed for these engines is 3750 RPM,

no load.

Maintenance Instructions

Maintenance, repair, or replacement of the emission

control devices and systems, which are being done at

the customers expense, may be performed by any

non-road engine repair establishment or individual.

Warranty repairs must be performed by an

authorized Kohler service outlet.

WARNING: Accidental Starts!

Disabling engine. Accidental starting can cause severe

injury or death. Before working on the engine or equipment,

disable the engine as follows: 1) Disconnect the spark plug

lead(s). 2) Disconnect negative (-) battery cable from battery.