Kohler Command Pro CV1000 Manuale d'uso - Pagina 9

Sfoglia online o scarica il pdf Manuale d'uso per Motore Kohler Command Pro CV1000. Kohler Command Pro CV1000 21. Vertical
Anche per Kohler Command Pro CV1000: Manuale d'uso (8 pagine)

Stampa la pagina

Oil Fill Cap/Dipstick

Figure 9. Oil Fill Cap/Dipstick.

4. Remove the oil fill cap/dipstick and check oil

level. The level should be between the "F" and

"L" marks. See Figure 10. If low, add oil of the

proper type up to the "F" mark. Reinstall the oil

fill cap/dipstick and thread tight. (Refer to Oil

Type on page 4.) Always check the level with the

dipstick before adding more oil.

Operating

Range

Figure 10. Oil Level Marks on Dipstick.

NOTE: To prevent extensive engine wear or damage,

always maintain the proper oil level in the

crankcase. Never operate the engine with the

oil level below the "L" mark or over the "F"

mark on the dipstick.

Oil Sentry™

Most engines are equipped with an Oil Sentry™ oil

pressure switch. On pressure switch equipped

models, if the oil pressure decreases below an

acceptable level, the Oil Sentry™ will either shut off

the engine or activate a warning signal, depending on

the application. See Figure 11.

Figure 11. Oil Sentry™ Pressure Switch.

NOTE: Make sure the oil level is checked BEFORE

EACH USE and is maintained up to the "F"

mark on the dipstick. This includes engines

equipped with Oil Sentry™ systems.

Change Oil and Filter, Service Oil Cooler

Change Oil

Change oil seasonally or every 150 hours of operation,

(more frequently under severe conditions). Refill with

service class SJ or higher oil as specified in the

Viscosity Grades table (Figure 2) on page 4.

Change the oil while the engine is still warm. The oil

will flow more freely and carry away more

impurities. Make sure the engine is level when filling,

checking, and changing the oil.

Change the oil as follows (see Figures 12 and 13):

1. To keep dirt, debris, etc., out of the engine, clean

the area around the oil fill cap/dipstick and one of

the drain plugs.

2. Remove one of the oil drain plugs and the oil fill

cap/dipstick. Be sure to allow ample time for

complete drainage.

3. Reinstall the drain plug. Make sure it is tightened

to 21.4 N·m (15.7 ft. lb.) torque.

4. Fill the crankcase, with new oil of the proper

type, to the "F" mark on the dipstick. Refer to Oil

Type on page 4. Always check the level with the

dipstick before adding more oil.

5. Reinstall the oil fill cap/dipstick and tighten

securely.

Pressure Switch