Kohler command pro PCH740 Manuale d'uso - Pagina 8

Sfoglia online o scarica il pdf Manuale d'uso per Motore Kohler command pro PCH740. Kohler command pro PCH740 12. Propane electronic fuel injection efi
Anche per Kohler command pro PCH740: Manuale d'uso (12 pagine)

Stampa la pagina

Air Cleaner

NOTE: Operating engine with loose or

damaged air cleaner components

could cause premature wear and

failure. Replace all bent or damaged

components.

NOTE: Paper element cannot be blown out

with compressed air.

Low-Proﬁ le

Loosen knob and remove air cleaner cover.

Precleaner:

1. Remove precleaner from paper element.

2. Replace or wash precleaner in warm water

with detergent. Rinse and allow to air dry.

3. Saturate precleaner with new engine oil;

squeeze out excess oil.

4. Reinstall precleaner over paper element.

Paper Element:

1. Clean area around element. Remove wing

nut, element cover, and paper element with

precleaner.

2. Separate precleaner from element; service

precleaner and replace paper element.

3. Check condition of rubber seal and replace if

necessary.

4. Install new paper element on base; install

precleaner over paper element; reinstall

element cover and secure with wing nut.

Reinstall air cleaner cover and secure with

knob.

Heavy-Duty

1. Unhook retaining clips and remove end

cap(s).

2. Check and clean inlet screen (if equipped).

3. Pull air cleaner element out of housing and

replace. Check condition of inner element;

replace when dirty.

4. Check all parts for wear, cracks, or damage,

and that ejector area is clean.

5. Install new element(s).

6. Reinstall end cap(s) with dust ejector valve/

screen down; secure with retaining clips.

Breather Tube (if equipped)

Ensure end of breather tube is properly

connected.

Oil Cooler (if equipped)

1. Clean ﬁ ns with a brush or compressed air.

2. Remove two screws securing oil cooler, and

tilt to clean back side.

3. Reinstall oil cooler.

Air Cooling

Never operate engine with heat shields or

guards removed.

Proper cooling is essential. To prevent over

heating, clean screens, cooling ﬁ ns, and other

external surfaces of engine. Avoid spraying

water at wiring harness or any electrical

components. See Maintenance Schedule.

Repairs/Service Parts

We recommend that you use a Kohler

authorized dealer for all maintenance, service,

and engine parts. To ﬁ nd a Kohler authorized

dealer visit KohlerEngines.com or call 1-800-

544-2444 (U.S. and Canada).

Leakage Check/Testing

With fuel valve fully opened, engine not

running, turn key switch ON. Check all fuel

system connections and lines for leaks using

soapy water. Any leakage must be corrected

before restarting engine. Have service

performed by a Kohler authorized dealer or

qualiﬁ ed propane personnel only.

Storage

If engine will be out of service for 2 months or

more follow procedure below.

1. Change oil while engine is still warm from

operation. Remove spark plug(s) and pour

about 1 oz. of engine oil into cylinder(s).

Replace spark plug(s) and crank engine

slowly to distribute oil.

2. Disconnect negative (-) battery cable.

3. Separate propane tank from unit and store

separately in an area designated for safe

propane tank storage.

4. Store engine in a clean, dry place.

KohlerEngines.com

WARNING

Hot Parts can cause severe

burns.

Do not touch engine while

operating or just after stopping.

24 590 52 Rev. --