Kohler 18RESL Funzionamento - Pagina 31

Sfoglia online o scarica il pdf Funzionamento per Generatore portatile Kohler 18RESL. Kohler 18RESL 48. Residential/commercial generator sets
Anche per Kohler 18RESL: Manuale di installazione (40 pagine), Manuale operativo (48 pagine)

Stampa la pagina

3.11 Storage Procedure

Perform the following storage procedure before

removing the generator set from service for three

months or longer. Follow the engine manufacturer's

recommendations for storage, if available.

Note: Run the generator set monthly whenever

possible.

3.11.1 Lubricating System

1. Operate the generator set until it reaches operating

temperature, or about 15 minutes.

2. Stop the generator set.

3. While the engine is still warm, drain the engine

lubrication oil from the engine crankcase.

4. Refill engine crankcase with oil. See Section 3.3.3

for oil recommendations.

5. Run the generator set for a few minutes to

distribute the clean oil.

6. Stop the generator set.

3.11.2 Fuel System

1. Start the generator set.

2. With the generator set running, shut off the gas

supply.

3. Run the generator set until the engine stops.

4. Place the generator set master switch in the OFF/

RESET position.

TP-6517 4/09

3.11.3 Cylinder Lubrication

1. Remove the spark plugs.

2. Pour one tablespoon of engine oil into each spark

plug hole. Install the spark plugs and ground the

spark plug leads. Do not connect the leads to the

plugs.

3. Toggle the generator set master switch to crank the

engine two or three revolutions to lubricate the

cylinders.

3.11.4 Exterior Preparation

1. Clean the exterior surface of the generator set.

2. Seal all openings in the engine with nonabsorbent

adhesive tape.

3. Mask all areas to be used for electrical contact.

4. Spread a light film of oil over unpainted metallic

surfaces to prevent rust and corrosion.

3.11.5 Battery

Perform battery storage last.

1. Place the generator set master switch in the OFF/

RESET position.

2. Disconnect the battery, negative (--) lead first.

3. Clean the battery. Refer to Section 3.8 for the

cleaning procedure.

4. Place the battery in a warm, dry location.

5. Connect the battery to a float/equalize battery

charger, or charge the battery monthly using a

trickle charger.

manufacturer's recommendations.

Section 3 Scheduled Maintenance, 12 kW Models

Follow the battery charger