A-Tach Mounts 50080 Manuale di avvio rapido

Sfoglia online o scarica il pdf Manuale di avvio rapido per Automobile Accessories A-Tach Mounts 50080. A-Tach Mounts 50080 2.

A-Tach # 50080

Designed for: Ford Expedition 2007-2017

For best results, hold the vehicle mount over the place where the mount attaches to the dash BEFORE

attaching the device holder to the vehicle mount to ensure a proper fit with the location. Most often the

mount will appear to be a little too big or small for the intended location. The vehicle mount must be

installed BEFORE a device holder is screwed onto the vehicle mount.

Once screwed together the products are considered used and non-refundable.

The vehicle mount is not designed to be attached and taken off the vehicle repeatedly or on a regular basis.

Once it is attached, it should remain attached until you would like to permanently remove it.

WARNING:

AVOID extreme heat conditions. It can damage the device and the mount.

(1) See additional notes on back. Clean the area

where the mount will attach. Remove the covering

from the tape. The tape will not leave any residue if

the mount is removed in the future. Insert the

seam tool into the seam between the frame around

the radio and the padded dash top. See photo.

(3) Pull out the seam tool and insert it into the

seam at the very front of the dash top tray.

Between the tray and the padded dash top. Not the

seam of the speaker grill.

See additional instructions on the back side.

ST-1

Mobile Device Mounts

NOTICE: A-Tach Mounts will not be responsible for

any damage to the vehicle due to the installation

and/or use of the product. The product has been

tested to fit securely to the listed vehicles.

Instructions are provided for your convenience.

You are responsible for the use of the product and

to determine if you have the skill to attach the

product without causing damage to your vehicle or

the product.

Read all instructions and view the photos before

attaching this product.

(2) Insert the lower edge of the mount into the

seam next to the seam tool. Press the mount all

the way into the seam until the back side of the

mount touches the padded dash top.

(4) Press the mount forward and hook the front

edge of the mount into the seam next to the seam

tool. Press down on the mount to make sure the

tape makes connection to the dash panel.

A-Tach