Acala Luna Manuale di istruzioni - Pagina 5

Sfoglia online o scarica il pdf Manuale di istruzioni per Sistemi di filtrazione dell'acqua Acala Luna. Acala Luna 11. Table water filters

1. Remove all packaging from the system and the filters. Clean the lid, base, upper tank and the

drinking water reservoir with a mild soap solution and rinse everything thoroughly with clean

water. Use a soft cloth or sponge. Never use soap or detergent on the filtering cartridge, mineral

stones, ceramic filter and the optional lime filter!

- Never use lukewarm, hot or boiling water to avoid cracks in the glass or plastic!

- Hygiene: Use disposable gloves for the assembly. Do not place the filters and stones on the

kitchen table or other shelves that come into contact with food.

Use fresh cloths or plates for this.

2. Place the drinking water container on the base.

3. Install the water tap:

Dry the area of the mounting point well. The two sealing rings are fitted to the inside and outside

of the drinking water tank.

Slide a sealing ring over the thread up to the end of the tap and then push the tap thread through

the hole in the glass container. Now slide the sealing ring for the inside over the end of the thread

in the water container. Tighten the screw by hand so that both sealing rings are tight against the

wall of the container and are watertight. The sealing rings may only deform slightly when

screwed in. If you turn the tap too tight, the glass may crack.

4. The filtering cartridge previously removed from the hygiene packaging must be soaked and

vented before insertion. Place the filter cartridge with the thread facing upwards in a container

with water. There must be at least 10-15 cm of water above the submerged cartridge. Leave the

filtering cartridge in the water for about 20 minutes.

Then screw the filtering cartridge loosely into the threaded ring and hang both together in the

drinking water container.

Optional: Open the lime filter can and remove the bag. Cut an opening and fill the contents of

the bag loosely. Close the lid until it clicks into place and soak the limescale filter in drinking

water for about 5 minutes. Now place the limescale filter in the threaded ring.

Optional: AcalaQuell Mini: Soak the limescale filter pad in drinking water for approx. 5 minutes

and place it on top of the filtering cartridge.

5. Place the ceramic filter in drinking water for approx. 20 minutes until the air escapes from the

filter and it is completely soaked. Place the ceramic filter in the opening provided in the upper

tank. Then push the sealing ring from below onto the thread of the ceramic filter. Hold the

ceramic filter lightly in your hand and tighten the wing nut only hand-tight.

6. Now place the upper tank with the ceramic filter on the glass drinking water container with the