Aqua 9+ AQ9-200GPD Manuale di installazione - Pagina 9

Sfoglia online o scarica il pdf Manuale di installazione per Sistema idrico Aqua 9+ AQ9-200GPD. Aqua 9+ AQ9-200GPD 13. Natural ionic calcium alkaline water system

Stampa la pagina

Installation Manual ::

Aqua 9+ Natural Ionic Calcium Water System

FEED WATER INSTALLATION

1. The feed water assembly consist of a 1/2" Metal adapter. Locate this part in the instal-

lation kit. (Note: Teflon tape should be used to prevent leaks)

2. Locate cold water angle shut off valve underneath the sink, usually on right side and turn it

off. Open cold water faucet to release the pressure. On single handle faucets, the hot water

may need to be turned off to prevent any hot water from crossing over. If water continues

to come out of the faucet with angle valve turned off, the house main water will have to be

turned off.

3. Disconnect the cold-water rinse tube and install the hex feed connector.(flex line) Loosen

nut and separate cold riser tube from faucet shank. Gently bend riser tube so that the hex

feed adapter fits on to faucet shank. Replace the existing at washer (if needed) with new

washer provided in installation kit onto cold riser tube. Re-install riser tube onto hex feed

adapter and tighten. (Solid copper riser tube) same procedure as ex tubing except you

must cut out a piece of the riser tube about 3/4" to 1" so the hex feed adapter can fit be-

tween faucet and riser tube. Example drawings are provided.

SYSTEM START UP

1. Slowly open the feed adapter valve to allow raw water to enter the system.

2. Move ball valve lever on storage tank to open position.

3. Tighten all nuts and connections which may have loosened in transit. Check all connec-

tions for leaks. Recheck several times during the first 48 hours of installation for any leaks,

tighten or re-tape as required.

4. Allow the system to run between 3 to 8 hours to fill the storage tank.

5. Turn on the faucet on top of the sink and let the water run for a few minutes clearing all new

tubes and filters. It is recommended that you fill the tank overnight and drain it to complete-

ly flush the system during initial start up. To do this raise the faucet handle to the up posi-

tion where it will remain open. When the water stops running close the faucet by lowering

the handle to the normal position.

6. The system will start automatically filling the tank again.

7. The system is ready to provide you with fresh clean water.