Aqua Clear 50 Manuale di istruzioni - Pagina 2

Sfoglia online o scarica il pdf Manuale di istruzioni per Sistemi di filtrazione dell'acqua Aqua Clear 50. Aqua Clear 50 13. Power filter

Stampa la pagina

WARNING-To guard against injury, basic safety precautions should be observed, including

the following:

1. For the complete enjoyment, use and understanding of this product,

READ AND FOLLOW ALL SAFETY INSTRUCTIONS

and all-important notices on the AquaClear

may result in damage to the unit.

2. DANGER-To avoid possible electrical shock, special care should be taken since water is

employed in the use of this equipment. For each of the following situations, do not

attempt repairs yourself; return the AquaClear

facility for service or discard the appliance.

If the AquaClear

then retrieve it. If any electrical component of the AquaClear

unplug it immediately.

II.

If the AquaClear

GFCI- Ground Fault Current Interrupter) switches off, disconnect the power supply cord

from mains and remove pump from water.

III. Carefully examine the AquaClear

plugged in if there is water on parts not intended to be wet.

IV. Do not operate any appliance if it has a damaged cord or plug, or if it is malfunctioning or

if it is dropped or damaged in any manner. The power cord of this appliance cannot be

replaced; if the cord is damaged, the appliance should be discarded. Never cut the cord.

V. To avoid the possibility of the AquaClear

position the unit to one side of a wall mounted receptacle to prevent water from dripping

onto the receptacle or plug. A "drip loop" (A) should be arranged to the receptacle. The

"drip loop" is the part of the cord below the level of the receptacle or the connector if an

extension cord is used, to prevent water traveling along the cord and coming into contact

with the receptacle. If the plug or receptacle does get wet,

Disconnect the fuse or circuit breaker that supplies power to the appliance. Then unplug

and examine for presence of water in the receptacle.

3. Close supervision is necessary when any appliance is used by or near children.

4. To avoid injury, do not contact moving parts or hot parts such as heaters, reflectors, lamp

bulbs, etc.

CAUTION-

Always unplug or disconnect all appliances in the aquarium

from electricity supply before placing hands in water, before putting on

or taking off parts and whilst the equipment is being installed,

maintained or handled. When inserting or removing the pump from the

water, always pull out the main electricity plug. Never yank cord to pull

plug from outlet. Grasp the plug and pull to disconnect. Always unplug

an appliance from an outlet when not in use.

6. Do not use this pump for other than intended use (i.e.: do not use in

swimming pools, bathrooms, etc.). The use of attachments not

recommended or sold by the appliance manufacturer may cause an

unsafe condition.

• Do not use this pump in swimming pools or other situations where

people are immersed.

• This pump is suitable for use in water temperatures up to 35 ˚C.

• Do not use this pump with inflammable or drinkable liquids.

IMPORTANT SAFEGUARDS

Motor Unit falls into the water

Motor Unit shows any sign of abnormal water leakage or if RCD (or

Power Filter before using. Failure to do so

Power Filter to an authorized service

DO NOT

Power Filter after installation. It should not be

Power Filter's plug or receptacle getting wet,

reach for it! First unplug it and

Power Filter gets wet,

DO NOT

unplug the cord.