Dexter Laundry COIN COMPACT DRYER Manuale dell'operatore - Pagina 11

Sfoglia online o scarica il pdf Manuale dell'operatore per Asciugatrice Dexter Laundry COIN COMPACT DRYER. Dexter Laundry COIN COMPACT DRYER 17.

OPERATING INSTRUCTIONS

1. Deposit coins to satisfy vend price display of idle dryer. Each deposit decreases the vend price

until the display changes to show the amount of time purchased. WARM or LOW light

illuminates.

2. Select drying cycle. Other cycle selections may be made now or later by pressing the

appropriate key (button).

3. Close the loading door. Press "START" and the dryer will start. The time remaining is

displayed in whole minutes (rounded up) and will count down each minute.

4. Clothes should be removed promptly after the cycle is completed to prevent excessive

wrinkling.

Once started, the "timer" cannot be stopped. However, extra coins will be acknowledged by

adding time to the display. The dryer may be stopped by opening the loading door, which

interrupts the drive motor and gas burners. Close the loading door and push "START" to restart

the dryer.

Cool-down time (owner programmable) is always part of the cycle time and is purchased by the

customer. For example, if cool-down time is 2 minutes, the last two minutes of the cycle will

have no heat.

DESCRIPTION OF CONTROLS

Credit for coins deposited, dryer time and temperature are controlled by an electronic control.

The large digital display shows vend price of an idle dryer, time purchased after coins are

deposited, temperature, and program information.

The three red indicator lights show the drying temperature selected. This selection may be made

anytime.

The drying temperature will be displayed when the start switch and the switch for selected

temperature are pressed at the same time.

All programmed data is protected from power interruption of any length, and the customer's cycle

is protected for up to 3 seconds. This is done without batteries.

The 3 temperature buttons and the start button become programming switches when the controller

is in the program mode as described below.