Aqua Cooler AC-PN8EBFY Manuale d'uso e manutenzione - Pagina 3

Sfoglia online o scarica il pdf Manuale d'uso e manutenzione per Sistema idrico Aqua Cooler AC-PN8EBFY. Aqua Cooler AC-PN8EBFY 12. Surface mounted bottle filler

Stampa la pagina

WHAT'S INCLUDED

TOOLS & HARDWARE REQUIRED:

•

Electrical drill/driver

•

Small tubing cutter for plastic line

•

1/4" nut driver

•

Means to cut 1-1/4" drain pipe

•

T15 Torx screwdriver and bit

•

4 appropriate anchors (not supplied)

Your Partner in Cool.

PREPARATION

PLEASE READ THESE INSTRUCTIONS BEFORE INSTALLING THE UNIT

Inspect the carton and water cooler for evidence of rough handling and concealed damage.

Damage claims should be filed with the carrier.

Locate and install plumbing and electrical service, if required, in accordance with Roughing in

Drawing. (See page 2)

The installation must be in accordance with AS/NZS 3500.1 and AS/NZS 3500.2, as well as the

instructions below. Pipe jointing and installation is a trade skill and Aqua Cooler recommended

this process is performed by qualified personnel only.

This drinking water cooler is designed to be operated at a water supply line pressure of up to 100

psi (690 kPa). A pressure regulator must be installed in front of units water inlet if water pressure

(including any possible pressure spikes) could exceed 100 psi (690kpa)

Check available power supply against the water cooler data plate to assure correct electrical

service. This drinking water cooler is intended to be connected to a 20A minimum ground

fault circuit interrupting (GFCI) device to meet UL requirements. The rear most 1 3/8" diameter

knockout in frame bottom is for an externally located electrical supply. Make sure knockout hole

edge is smooth and free of any burrs. Use of a Heyco bushing #2184 in knocked out hole is

recommended in order to prevent damage to service cord and to close up excess opening around

cord. Route cord so it does not interfere with ADA space requirements.