Aqua Creek F-600TLNA Manuale - Pagina 5

Sfoglia online o scarica il pdf Manuale per Sistemi di sollevamento Aqua Creek F-600TLNA. Aqua Creek F-600TLNA 14.

ADA Fixing Insert Installation (Commercial Applications)

STEP 1: INSTALLING THE LIFT ON THE POOL/SPA DECK

1. Due to the indexed anchor and keyed base of the lift, we recommend installation of the fixing insert after

the concrete has cured and you are ready to install the lift into the anchor.

2. Place the main assembly in the anchor and turn until the locking pin on the shaft of the lift lines up and

drops into the locking pin slot in the anchor. DO NOT LIFT THE MAIN ASSEMBLY BY USING THE ELECTRIC

RAM AS A HANDLE. If the transport cart was ordered with the lift, it can be used effectively here. If not,

use two people.

3. Mark the location for the fixing anchor hole and remove the lift.

4. Drill the hole with a 1 1/4 inch core drill or roto-hammer to a depth of about 4 1/2 inches.

5. Clean the hole out and make sure it is dry. Thread the 1/2 inch bolt into the top of the PVC fixing anchor

and test fit to verify it can be mounted perpendicular. See Step 1 below.

6. Using a two part construction epoxy, fill the hole approximately half full and carefully insert the PVC fixing

anchor into the hole, twisting as you push down to evenly spread the epoxy.

7. Allow the epoxy to cure before securing the lift.

8. Re-install the lift into the anchor and using the 1/2 inch bolt and washer, carefully thread into the installed

anchor until snug. TO PREVENT BREAKING THE FIXING BRACKET, DO NOT OVERTIGHTEN!

1/2" X 2"

HEX BOLT

1/2" FLAT

WASHER

LOCKING-PIN

LOCKING-PIN SLOT

FIXING ANCHOR

STEP 1

(see pg 4, FIGURE A)

TITAN 600

MAIN ASSEMBLY

POST

DECK

Revised 4/14/17