Aqua Creek PRO SPA 60 Manuale - Pagina 9

Sfoglia online o scarica il pdf Manuale per Sistemi di sollevamento Aqua Creek PRO SPA 60. Aqua Creek PRO SPA 60 17.

Stampa la pagina

SAFETY & MAINTENANCE INSTRUCTIONS

1. Do not play on or around this lift

2. Check the PRO SPA Lift

that all hardware is properly tightened. If there are any worn parts, replace them

BEFORE using the PRO SPA Lift

687-3552 to order any parts.

3. Aqua Creek Products, LLC shall be grounded per local codes.

4. At least ONCE A WEEK, thePRO SPA Lift

Do not spray the PRO SPA Lift

Wipe all surfaces clean with a damp, non-abrasive cloth. When cleaning the

PRO SPA Lift

disinfectants.

5. Always read the label instructions on any cleaner carefully before applying it to a

surface.

6. The WARNING & INTENDED USE labels on the PRO SPA Lift

maintained in readable fashion. If they become unreadable or faded, please

replace the immediately. Replacement labels are available from AQUA CREEK

PRODUCTS LLC. 1-888-687-3552.

CARE OF YOUR LIFT

Routine cleaning is an absolute necessity to ensure the integrity of the lift. Note that the Aqua Creek Pool Lift should

not be stored in a pump room or in a storage room where pool chemicals are kept. Storing the lift near pool chemicals

may cause rusting and other damage to occur. Your Aqua Creek stainless steel lift is powder coated to protect the

stainless steel from rusting. Most rusting will occur at weld points, crevices, under gaskets, rivets or bolt heads.

The choice of a proper cleaning product is up to the consumer and there are many to choose from. Depending on the

type of cleaning and the degree of contamination (rusting), some products are better than others. For routine cleaning

the products most recommended are gentle soaps or detergents or dilute mixtures of ammonia. For stubborn spots and

stains try using soft scrub with some brisk rubbing.

DO NOT USE POOL WATER TO CLEAN USE ONLY FRESH WATER

If the lift is used DAILY make sure to wash the lift at the end of the day. Wash the lift off using a mild soap and a soft

cloth. Make sure to pay special attention to weld points and crevices. Do not use a bristled brush or steel wool to clean

the lift. Check that the lift is working properly and then place the battery on the charger. It is recommended that the

battery be charged after every day of use.

If the lift is used WEEKLY follow the same steps as above. Also be sure to check all of the contact points (terminals)

for damage or corrosion. If you notice corrosion gently clean the terminals. To clean corrosion from the terminals use a

q-tip and some rubbing alcohol. If the corrosion is particularly stubborn try using a 3M scotch brite pad, but be careful

not to damage the terminals. Apply dielectric grease to the terminals after cleaning them. This will help to prevent

further corrosion. Do not leave the battery on the lift. Always store the battery on the charger whenever the lift is not

being used.

If the lift is used MONTHLY follow the same steps as above. Also check the nuts and bolts to make sure they are

securely fastened (this is always a good idea, no matter how often or infrequently the lift is used). Also make sure to

store the battery on the charger and not on the lift. Leaving the battery on the lift for extended periods will significantly

shorten the battery's lifespan.

If the lift is being STORED for an extended period of time follow all of the steps above. Check for rusting at all

crevice and weld points. If you notice rusting spray some WD-40 on the affected area and take a 3M scotch brite pad

and rub briskly. Afterwards be sure to wash and rinse the lift again with soap and water. When storing the lift make

sure it is in a dry area and covered. DO NOT STORE in or around pool chemicals.

before each use to assure there are no worn parts and

. You can call our customer service at 1-888-

24v battery unit directly with any pressure.

, use non-abrasive soap and water. Avoid harsh chemicals and

must be cleaned with fresh water.

need to be