Avlite AV-HL-FL Manuale di avvio rapido

Sfoglia online o scarica il pdf Manuale di avvio rapido per Luce a diluvio Avlite AV-HL-FL. Avlite AV-HL-FL 2.

Quick Start Guide

AV-HL-FL

Introduction

The purpose of this Quick Start Guide is to present a brief summary of the steps involved in deploying your Avlite provided floodlight. Your product will

consist of a prewired and preassembled AV-HL-FL light fixture (and solar assembly for solar variants) on a frangible mount assembly.

AV-HL-FL

Avlite's floodlight has been specifically designed for helipads to provide uniform surface lighting where the TLOF and FATO lights need to be

supplemented with floodlighting. The fixture is available in solar (PV) and wired versions (DC and Universal Mains UM).

Theory Of Operations

AV-HL-FL-PV model: The solar module of the light converts sunlight to an electrical current that is used to charge the battery during daylight

hours. The battery provides power to operate the light at night. For optimum solar charge performance, it is recommended that the unit is

orientated with the solar panels facing East-West.

AV-HL-FL-DC and UM models: The wired fixtures are connected to one another as part of a daisy chain configuration where power, control and

monitoring points are wired in parallel utilizing a single cable route per lighting circuit and junction boxes per fixture. The HLS is controlled from

a primary Helipad Controller which provides power and state transitions to each connected lighting circuit.

Install the LED Floodlight Units and solar

assembly (if required)

Set up a number of concrete pads at equidistant points

around the TLOF at ground level. The concrete pads

should have a dimension of approximately 400mm

x 400mm with sufficient depth depending on soil

conditions. Embed 4 bolts, using the Mount Base as a

placing template, fitting level when dry. As an alternative,

it is possible to use rubber tiles instead of concrete pads.

Repeat for installing solar assembly, which requires two

concrete pads with 400 mm between the mounting

centrepoints.

AV-HL-FL-PV model only: Connect the LED Floodlight Unit

to the Solar Assembly using the Avlite supplied 2m long

cable.

LED Floodlight Unit - Side View

Solar Assembly - Front View

AUSTRALIA

USA

+61 (0)3 5977 6128

+1 (603) 737 1310

Adjustment of LED Floodlight Unit

Point the LED Floodlight Unit into the desired direction,

ensuring that the floodlight unit is level and the height is

below 250mm.

Loosen the two nut screws at the back of the LED

Floodlight Unit.

Adjust the Light Head as required by turning the Tilt

Screw Nut. A spring between the LED Floodlight Unit

and the Light Head will provide the required tension.

After the adjustment secure the tilt/position of the Light

Head by tightening the Locking Screw Nut.

If required, tighten the hex sockets at the Frangible

Sleeve

[email protected]