Aqua Creek Products F-MTY400 Manuale - Pagina 5

Sfoglia online o scarica il pdf Manuale per Apparecchiature di illuminazione Aqua Creek Products F-MTY400. Aqua Creek Products F-MTY400 13.

1
LIFT THE MIGHTY 400 MAST ASSEMBLY FROM THE SHIPPING
CONTAINER. INSERT THE 1.90" [48mm] POST OF THE MAST
ASSEMBLY INTO THE DECK ANCHOR. EASE THE MAST ASSEMBLY
DOWN UNTIL IT RESTS ON THE DECK SURFACE. ROTATE THE
BASE UNTIL THE FIXING ANCHOR HOLE LINES UP WITH THE
FIXING ANCHOR. INSTALL THE 1/2"-13X1 1/2" HEX BOLT AND
WASHER (PROVIDED IN THE STOCK BOX) TO HOLD DOWN THE
LIFT. TIGHTEN THE BOLT.
2
SLIDE THE SEAT CRADLE
ASSEMBLY UP THROUGH THE TOP
CASING OF THE MAST ASSEMBLY AND
CONNECT USING THE SUPPLIED 5/16"
HEX BOLTS, WASHERS AND NYLOCK
NUTS. FOR STANDARD POOL
CONFIGURATION THE SEAT CRADLE
WILL BE CONNECTED AT THE TOP TWO
HOLES. HOWEVER, THE SEAT CRADLE
CAN BE ADJUSTED UP TO 6" HIGHER,
IN 2" INCREMENTS, IF THERE IS A
NEED FOR IT.
WITHOUT BOTH HEX BOLTS
INSTALLED!
NOTE: BE CAREFUL NOT TO
OVERTIGHTEN BOLTS. OVER-
TIGHTENING CAN CAUSE DAMAGE AND
COMPROMISE THE SAFETY OF YOUR
LIFT.
FIXING ANCHOR HOLE
POST
FIG. 01
PRODUCT ASSEMBLY
NEVER USE THE LIFT
TOP CASING
SEAT CRADLE
Aqua Creek Products
FIG. 02
9/28/2022 1:39:29 PM PAGE - 5