Aqua Creek Products F-RNGR2-02 Manuale - Pagina 5

Sfoglia online o scarica il pdf Manuale per Apparecchiature di illuminazione Aqua Creek Products F-RNGR2-02. Aqua Creek Products F-RNGR2-02 16. Pool lift

Stampa la pagina

Anchor Installation: Core-Drill Retro-Fit

NOTE: FOR DECKS 6" THICK OR MORE, 2500PSI MINIMUM STRENGTH CONCRETE REQUIRED

You will need:

• Core drill and 1½" core drill bit

• Tape measure

• Marking pen

• Hammer

• Cold chisel

• Torpedo level

• High strength 2-part construction epoxy*

• Masking tape

• Black electrical tape (optional)

• Anti-seize packet

*Aqua Creek recommends either Hilti™ Brand HIT RE-500-

SD or Simpson™ brand SET-XP or equivalent

FIGURE 2

NOTE: Local bonding regulations may require you to drill one hole larger than the others in order to bond at least

one of the anchor inserts. You may need to saw cut a portion of your deck.

See "Saw Cutting Retro-Fit Instructions" on page 7.

Remove the nuts and the black protective coverings from the threaded anchor inserts.

(not included)

Anchor jig plate with hardware

Mark the 4 hole locations on your deck using

the larger holes of the anchor jig plate as a

template. For ADA compliance, confirm the center

of the jig plate front holes are 14.5 to 19 inches

from the pool's edge.

Drill the 4 hole locations to 4 1/2 inches deep

using the 1 1/2 inch drill bit. Clear all debris and

ensure holes are completely dry.

NOTE: Create a depth marker on the drill bit with black

electrical tape to make sure you drill to the right depth.

SEE FIGURE 2

Revised 6/17/19