A.J.Antunes 9100480 Manuale d'uso - Pagina 9
Sfoglia online o scarica il pdf Manuale d'uso per Elettrodomestici da cucina A.J.Antunes 9100480. A.J.Antunes 9100480 20. Miracle steamer
Stampa la pagina
READY
1500
SINGLE SHOT
UP
DOWN
PRGM
START/STOP
A. Total Cycle Time
READY
00
SINGLE SHOT
UP
DOWN
PRGM
START/STOP
C. Total Cycle Seconds
READY
20
SINGLE SHOT
UP
DOWN
PRGM
START/STOP
E. SHO Time in Seconds
READY
H20
SINGLE SHOT
UP
DOWN
PRGM
START/STOP
G. H2O Cycle
Figure 4. Control Programming Sequence
P/N 1010456 Rev. C 08/12
OPERATION (continued)
READY
15
SINGLE SHOT
UP
DOWN
PRGM
START/STOP
B. Total Cycle Minutes
READY
SHO
SINGLE SHOT
UP
DOWN
PRGM
START/STOP
D. SHO Cycle
READY
00
SINGLE SHOT
UP
DOWN
PRGM
START/STOP
F. SHO Time in Minutes
READY
SINGLE SHOT
UP
DOWN
PRGM
START/STOP
H. H2O Setting
MIRACLE STEAMER
6. Press and release
change the SHO in seconds (Figure 4, Item E).
7. Press and release
change the SHO in minutes (Figure 4, Item F).
8. Press and release
played (Figure 4, Item G).
9. To change the H2O (Steam Shot time), press and
release the PROGRAM button again to display
the setting (Figure 4, Item H). Use ▲ or ▼ to
increase or decrease the time.
10. Press the START/STOP or OPERATE buttons
to store the changes, exit the PROGRAM Mode,
and initiate the cooking cycle.
NOTE: 120V steamers are factory programmed for
the following recommended settings:
• Total Cycle Time (CYC) = 2 min., 00 secs.
(Range: 3 seconds to 99 minutes 59 seconds)
• Shot Interval Time (SHO) = 00 min., 20 secs.
(Range: 3 seconds to 5 minutes 59 seconds)
• Steam Shot Time (H2O) = 0_80
(Range: 0_10 second to 2_50)
NOTE: 208V and 220-240V steamers are factory pro-
grammed for the following recommended settings:
• Total Cycle Time (CYC) = 15 min., 00 secs.
(Range: 3 seconds to 99 minutes 59 seconds)
• Shot Interval Time (SHO) = 00 min., 20 secs.
(Range: 3 seconds to 5 minutes 59 seconds)
• Steam Shot Time (H2O) = 1_00
(Range: 0_10 second to 2_50)
NOTE: The START/STOP or OPERATE buttons may
be pressed any time during programming to store
the changes and exit the PROGRAM Mode.
NOTE: If a change is not made within 5 seconds
at any time during the programming process, all
changes made up to that point are stored in memory
and the control reverts to the OPERATION Mode.
9
and then press ▲ or ▼ to
again and press ▲ or ▼ to
and "H2O" will be dis-
A.J. Antunes & Co.