Bilberry Stoves 10kW Stove Manuale di installazione e istruzioni per l'uso - Pagina 11

Sfoglia online o scarica il pdf Manuale di installazione e istruzioni per l'uso per Stufa Bilberry Stoves 10kW Stove. Bilberry Stoves 10kW Stove 20.

DRAUGHT CONDITIONS

If smoke spillage occurs when the firedoor is opened, it is probably due to poor chimney draught. This type of

stove requires at least 0.06" w.g. of chimney draught to achieve satisfactory combustion and smoke spillage

prevention. However, in cases where the stove door is opened too vigorously you could expect that slight

smoke spillage may occur.

If you have any doubts, you may want to have your installer measure the draught in the chimney.

The chimney's draught is the resulting effect within the flue caused by the difference in temperature within the

flue and the cooler temperature outside. Other factors that can influence the level of draught include the length

of the flue, insulation of the chimney, adverse weather conditions, tall buildings or trees nearby the flue termi-

nal.

BILBERRY SOLID FUEL STOVES

COAL, ANTHRACITE, PEAT, WOOD SYNTHETIC LOGS, OR OTHER FUELS. "Never use gasoline" gasoline

type lantern fuel, kerosene, charcoal lighter fluid or similar liquids to start or 'freshen up' a fire in this heater.

Keep all such liquid well away from the heater while in use. Operate stove only with fuelling door and ashpit

doors closed. This heater is hot whilst in operation. Keep children, clothing and furniture a safe distance away.

The stove output levels are assessed on standard House Coals of good quality. Reduced outputs will result

when fuels of lower calorific values are used. Wood logs up to 406mm (16") long are suitable.

All fuels should be stored under cover and kept as dry as possible prior to use.

NEVER BURN HOUSEHOLD RUBBISH OR ANY FORM OF PETROLEUM BASED COKE IN THIS STOVE.

Odours on First Lighting of The Stove:

Painted stoves may emit an unpleasant odour when used for the first time. The room must be thoroughly ven-

tilated. (ie. it is recommended to open all windows in the room in which the appliance is fitted). Let the fire

burn with a high draught until all traces of the odour have dissipated and no smoke or smells can be detected.

The amount of heat produced by the stove is regulated using three air controls. The primary air supply, where

air passes up through the riddling grate, is controlled using the spin valve, and the secondary air (airwash sys-

tem), which is supplied to the combustion over the glass and is controlled using the upper air control. A third

air inlet (normally named secondary air) provides a constant, pre-heated air supply to the combustion just above

the fire, it is controlled using the air control below the ash lip. This air supply doesn't normally need to be reg-

ulated, however it is necessary to keep this air supply open always.

Fig.6

WARNING

ENSURE TOP BAFFLE IS CORRECTLY IN

PLACE BEFORE LIGHTING THE STOVE.

See Fig.6.

Top Baffle in Place