CP EBDHS-PRM-LT30 Manuale del prodotto - Pagina 5

Sfoglia online o scarica il pdf Manuale del prodotto per Sensori di sicurezza CP EBDHS-PRM-LT30. CP EBDHS-PRM-LT30 8. Ceiling pir hs presence detector, low temperature

Stampa la pagina

Assembly

The EBDHS-PRM-LT30

may be supplied in two

parts. Follow the

instructions to

assemble.

The EBDHS-PRM-LT30 is designed to be mounted using either:



Flush fixing, or



Surface fixing, using the optional Surface Mounting Box (part no. DBB).

Both methods are illustrated below.

Use the supplied gasket to ensure IP rating (not compatible with Surface Mounting Box part no. DBB).

Flush Fixing

Warning - be careful

bending springs when

mounting unit.

Surface Fixing

Wire stripping details

When power is applied to the unit, the load will turn on immediately.

Set the timeout to 10 seconds, vacate the room or remain very still and wait for the load to switch off .

Check that the load switches on when movement is detected.

The unit is now ready for programming.

Push-in sensor

head connector to

mating socket on

power supply unit.

Locate sensor head

onto power supply

and clockwise rotate

until locked.

Remove connector

cover

Hole Ø64mm

50mm or 60mm fixing centres

Pull out spring tab and rotate

spring arm as shown

Installation

Important

Ensure that the cables are formed as shown

before affixing the cable clamp. The clamp

MUST clamp the outer sheath(s) only.

Bend cores as shown.

Power-up test procedure