ALLIED ELECTRONICS NeXGen Prime Manuale d'uso - Pagina 8

Sfoglia online o scarica il pdf Manuale d'uso per Controllore ALLIED ELECTRONICS NeXGen Prime. ALLIED ELECTRONICS NeXGen Prime 9. Forecourt controllers

Stampa la pagina

Use DGS to set a different IP address based on site specifics.

Peripheral Access

Payment terminals and other forecourt peripherals employing Ethernet communications must be

configured so that they are accessible to the controller. In accordance with PA-DSS, this network

segment must be segregated from any public network segments.

2.2 Default RS-232 Serial Port Assignments

Default serial port assignments are the same as Aegis and NXG.

COM

Default Usage

POS

TLS

CRW

FPS

These serial ports can be defined via NEXGEN.INI, located in C:\. NXG-P controllers can be

configured via the NEXGEN.INI and are read only at boot time. A warm-start or cold-start is

required for them to take effect. Please contact Allied Support for more information on the

NEXGEN.INI file.

Startup

After power is applied the INtime RTOS will start up and run the ANDI application.

3.1 Audible feedback

a. BIOS boot: one or several short beeps, shortly after power is applied.

b. ANDI application startup: two beeps

c. ANDI has acquired an IP address: three beeps

3.2 Shutdown

The entire system may be safely shut down by pressing the power key.

If a shutdown is initiated, it is critical to wait for the shutdown to complete before

removing the power cord. Shutdown is complete when the power and disk LEDs go out

and the fan stops spinning.

Firmware Download

ANDI firmware downloads are completed via the Allied DGS utility.

NeXGen Prime

Page 8 of 9