aqua metro Contoil DFM 8EDM Istruzioni per il montaggio e il funzionamento - Pagina 9

Sfoglia online o scarica il pdf Istruzioni per il montaggio e il funzionamento per Data Loggers aqua metro Contoil DFM 8EDM. aqua metro Contoil DFM 8EDM 20.

Stampa la pagina

Configuration overview

Schematic of a configuration

Tank

Pre-Filter

Installation advices

• The sensors have to be always protected by a fuel filter. The max. mesh size depends on the sensor size. The original truck filter is ide-

al for all sensor sizes.

• Be aware, that all the fuel which is passing through the supply line sensor AND is not consumed by the engine, MUST return through

the return line sensor to the tank.

• A leak line of the injector MUST be returned on the return line and before the return flow meter

• If the sensors are marked with S and R, install the S-sensor in the SUPPLY and the R-sensor in the RETURN pipe.

• The arrow on the sensors must be show in the flow direction.

• The sensors must be absolutely free of gas inclusions.

• High pressure hammers from injection pump have to be avoided on flow sensors (for example, with a min. 2 meter wounded hose

between sensor meter on the supply line and the injection pump).

• Install the DFM-BC on the cabin floor, on the car dashboard or on the cabin top; but always in good readable and accessible position.

• For a good and professional installation of the Board Computer (DFM-BC) we recommend the Mounting Bracket Kit (part no. 80485)

For your security...

• DO NOT program or change parameters while you drive. This is / may be dangerous for you and the other traffic

participants.

• During the electrical installation disconnect the vehicle battery.

• Be careful when disconnecting the pipes (exit of fuel will occur).

• After installation check all pipes for leaks.

CONTOIL

DFM 8EDM

CONTOIL

DFM 8EDM

Pump

Engine

Fine-Filter

Connecting to a Fleet Manager,

GPS Tracking System or Host

Mechanical

Injection-Pump