Aqua One UFO 550 Manuale di istruzioni - Pagina 9
Sfoglia online o scarica il pdf Manuale di istruzioni per Prodotto per la cura degli animali domestici Aqua One UFO 550. Aqua One UFO 550 13.
Stampa la pagina
- 1. Important Safeguards
- 1. Important Safeguards
- 2. Before First Use / Preparation
- 2. Before First Use / Preparation
- 3. Set up Instructions
- 3. Set up Instructions
- 4. Tank Maintenance
- 4. Tank Maintenance
- 5. Filter Maintenance
- 5. Filter Maintenance
- 6. Filter Media
- 6. Filter Media
- 7. Troubleshooting
- 7. Troubleshooting
Filter Maintenance
WEEKLY
1. Turn the Power Head off.
2. Remove the Lid from the Filter Unit.
3. Remove the Outlet from the top of the
Power Head.
4. Remove the Black Sponges and Wool
Pads from the Filter Unit.
5. Empty a small amount of water from the
aquarium into a bucket.
6. Rinse the Black Sponges in the bucket.
Discard the used water; do not add it back into
the aquarium.
7. Rinse the Wool Pads out under the tap, rinse
thoroughly.
8. Re-insert the Wool Pads and Black
Sponges.
9. Then connect the Outlet back in to the top of
the Power Head. Make sure the holes of the
Spray Bar are pointing down onto the Black
Sponge and that the end of the Spray Bars
have their caps fitted.
10. Ensure the aquarium is full. Refer to Fig 13
11. Turn the Power Head back on and ensure
that water is flowing out of the Spray Bar.
12. Replace the Lid on the Filter Unit.
13. Add Filter Supplement .
MONTHLY
See diagrams on next page...
1. Turn the power off. And unplug both power
leads.
2. Remove the Light Unit and Place it some-
where safe away from water and where it will
not be broken / damaged.
3. Remove Filter Unit from aquarium and take
to sink.
4. Disconnect Spray Bar and T Junction and
clean with double ended pipe brush.
5. Slide the Power Head off the bottom of the
Filter Unit Fig 1.
6. Pull Impeller Cap off bottom of Power Head,
this will uncover Impeller.
7. Hold the Power Head with both hands. With
your left hand press in and hold the tabs on the
Impeller Cap marked with this symbol: (Fig 2)
Then pull the Impeller Cap away from the
Power Head. Fig 3
8. Grasp the Impeller Blades and remove from
the Impeller Well. Fig 4
9. Use a double ended pipe brush to clean Impel-
ler and inside of Impeller Well. Fig 5
10 Also run a pipe brush through the outlet at the
top of the Power Head.
11. Clean the Intake Pipe and Strainer
thoroughly.
12. Reconnect all parts and place Filter Unit
back onto the aquarium.
13. Ensure the power lead is not wet and plug it
back in. Fig 6
14. Turn the power back on and check that water
is flowing though the Spray Bar.
15. Replace the Light Unit and Lid.
YEARLY
The Ceramic Noodles are designed to be
maintenance free, NEVER RINSE THEM IN
TAP WATER.
See Hints & Tips for Best Results for more
information.