Aqua One NanoFlow 150 Manuale - Pagina 5
Sfoglia online o scarica il pdf Manuale per Sistemi di filtrazione dell'acqua Aqua One NanoFlow 150. Aqua One NanoFlow 150 8.
Installation
1. Decide on which outlet option to use.
2. If the filter is to be used in a shallow aquarium,
the filter can be turned on the side using the
elbow to direct the flow as required.
3. If the venturi is required, push the venturi
outlet directly into pump outlet, hang airline
outside of your aquarium.
4. Mount the filter to the corner of your
aquarium, secure using the suction cups on the
pump body and rear filter cover. Ensure the filter
is at a suitable height, it is recommended that
the water exiting the filter is breaking the water
surface but not splashing.
5. Ensure your hands are dry, plug the filter in at
the power outlet. Switch the power on.
6. Adjust the flow rate using the flow controller
on the top of the filter.
Maintenance
1. Ensure your hands are dry and unplug the
filter from the power supply. Take to sink.
2. Remove the pump body from the filter unit,
this will allow access to the media cartridges.
3. Remove the media cartridges from the filter
unit.
4. Rinse the sponge and squeeze gently a
few times in a bucket of aquarium water. It is
important to not wash the sponge too thoroughly
and never wash it in tap water.
Fig 1
5. Gently rinse the cartridge containing the
ceramic noodles in aquarium water. It is
important that the noodles are never washed in
tap water.
6. The carbon pouch should be replaced every
4-6 weeks. If the pouch is not being replaced, it
should be rinsed gently in aquarium water.
7. Clean the impeller at least once a month.
Accessing The Impeller
1. Grasp the pump body with one hand and filter
casing with the other and gently pull apart.
Fig 2
2. Remove the impeller cover to gain access to
the impeller.
3. Pull impeller from the motor and rinse
properly. Use an Aqua One double ended pipe
brush to clean the impeller and the impeller well
and also any of the outlet options that are being
used.
4. Put the filter back together and return to the
aquarium. Ensure your hand is not wet, plug in
at the power supply and turn on.
5