ABACUS Pisces Pacchetto informativo - Pagina 12

Sfoglia online o scarica il pdf Pacchetto informativo per Vasche da bagno ABACUS Pisces. ABACUS Pisces 17. Adjustable height bath

www.abacushealthcare.com

0808 256 4249

Pisces 1700 Installation Requirements

Items

Items supplied with the kit should be as follows:

Bath Shell x 1 with 4 x inbuilt seal housings for the platform rods

Bathing/Changing Platform

Bath Surround Panels x 1

End Base units. Left x 1. Right x 1.

Bath Frame with platform support rods

Information pack

Flexible water feed pipes x2

Bath Shower Mixer Tap (TMV) x1

Base unit Fixing kit (Comprising Bolts /screws – see Floor fixing kit on page 12)

Installation

Preparation of Site

a) Carefully remove all packaging and inspect the bath thoroughly. Note: Do not use sharp knives or

instruments to remove packaging around the finished surface areas of the bath.

b) Ensure all component parts are present before proceeding to remove any existing facilities. It is

important to ensure the complete kit is there. If there are ANY components missing contact the office and

quote the number on the side of the bath.

c) Prepare the floor area and ensure it is flat, level and structurally sound & there are NO SERVICES BURIED

within the floor fixing area.

Bath Fitting

Ensure that the Site is ready as per the Pre Installation Requirements detailed in this pack.

REMOVE TRANSPORT CASTORS IF STILL IN PLACE. REMOVE TRANSPORT STRAPS - SEE PAGE 3.

Base Plate Fixing – THIS SECTION IS CRITICAL

See the Floor Fixing kit for the correct floor fixings to be used

Using the foot fixing template on the pre-install detail on page 4, mark out the floor fixing holes for the End

Base unit Feet. This template information is repeated (FIG 1)

Starting with the bath tap end base plate, drill 2 holes for the appropriate fittings (Using the 400mm or

484mm centres) in the floor ensuring they are into a solid construction.

Clean out the holes & using the correct floor installation kit tighten up fully making sure the frame is vertical

in both planes. Repeat with the foot end base plate. Use the other holes to ensure extra fixing is made

but these are only additional and not critical.

It is important that both end plates are completely vertical (FIG2)

Abacus Pisces 069/Info.P 04/14v1a