ABACUS Pisces Pacchetto informativo - Pagina 8
Sfoglia online o scarica il pdf Pacchetto informativo per Vasche da bagno ABACUS Pisces. ABACUS Pisces 17. Adjustable height bath
Stampa la pagina
If s the bath requires a Thermostatic Mixing Valve, please read the following which outlines how a TMV may affect the
use of your bath.
The working parameters of the TMV require a water pressure of 1-5 bar with a maximum pressure loss ratio of no
greater than 10:1 between hot and cold feeds.
The maximum bath water temperature according to DO8 is no higher than
is 39°C.
It is important to note that a pressure difference between hot and cold pipes will have a great effect on the time it
takes to fill a bath, i.e;
Hot water 1.4 bar and Cold water 2.4 bar = Approx. 9min. to fill bath with 180 litres
Hot water 2.2 bar and Cold water 2.2 bar = Approx. 5min. to fill bath with 180 litres
If in doubt a pressure test should be carried out prior to installation of the bath, and if required a booster pump or
pressure reducing valve fitted, as required.
Note – It is a requirement that at least 2 firm fixings are made for each base plate.
The table below shows which type of fixing should be used based on the flooring.
Should you experience difficulties please call our Technical Support Line 0870 066 0809
Abacus Pisces 069/Info.P 04/14v1a
1700 Pre Installation Requirements
Water Pressure Requirement
POWER BATH FLOOR FIXING KIT
(Supplied with Bath)
M10 x 70mm
M8 x 70mm
10 x 50mm Nylon Fixing Plugs 4
White Hole Cover Plugs
Base Plate Fixings
M8 Coach Screws
M8 Coach Screws with nylon Plug
*Sleeve Bolts
M8 Coach Screws with nylon Plug**
M8 Coach Screws with nylon Plug
*M10 Sleeve Bolts
*Sleeve bolts will not grip unless the hole is cleaned out first
** Plugs to be fixed into lower section of floor and not floating section
Contents Pack
Sleeve Bolts
4
Coach Screws 4
4
Floor Material
Joist & Noggin
Brick & Block
Compound
Floating
Block & Beam
Concrete
8
46°C
and the maximum for the shower