AVP Synthesizers COSMWAVE FX Manuale d'uso - Pagina 5

Sfoglia online o scarica il pdf Manuale d'uso per Apparecchiature di registrazione AVP Synthesizers COSMWAVE FX. AVP Synthesizers COSMWAVE FX 9.

To use COSMWAVE FX in INDIVIDUAL mode, each of the effects need to be

connected in a standard way - the inputs and outputs in each section are connected

respectively to the signal source and mixer or amplifying device. The FX MODE

switch must be set in the INDIVIDUAL position in order for the sections to work

separately from each other.

② PHASER section.

Fully analog effect, therefore it has a permissible level of analog noise at the output.

Note: the noise level depends on the position of the adjustment controls.

The phaser consists of 8 stages and a low-frequency oscillator, which modulates all 8

stages by a triangular waveform (instead of LFO, you can use the MANUAL knob to

modulate the stages manually).

Phaser section has 5 controls:

 INPUT - sets the input signal level;

 MANUAL - allows you to manually adjust the tone (stages) of the effect;

 RESONANCE - adjusts the saturation of the effect;

 DEPTH - adjusts the depth of the phaser modulation;

 RATE - adjusts the frequency of the phaser modulation.

There is a toggle switch to turn the unit on/off (bypass)

③ DELAY section.

A hybrid effect with the path of the direct signal being analog while the delay line is a

digital microprocessor. The delay time can be adjusted from 0 to 2 sec with a

feedback time of over 1 minute.

Delay section has 4 regulators:

 INPUT - sets the input signal level;

 MIX - amount of effect applied to the direct signal;

 FEEDBACK - adjusts the number of times a delayed signal is repeated;

 DELAY TIME - adjusts the delay time of the signal.