AVPro Edge AC-EX70-SC2-R Manuale di avvio rapido - Pagina 3
Sfoglia online o scarica il pdf Manuale di avvio rapido per Estensore AVPro Edge AC-EX70-SC2-R. AVPro Edge AC-EX70-SC2-R 4. A 70 meter hdbaset receiver with our sc2 scaler built in
Anche per AVPro Edge AC-EX70-SC2-R: Manuale d'uso (17 pagine)
Test patterns
There are three built in Test patterns available. To Enable and
Disable press "TEST Pattern" button to cycle through the 4 resolutions. The SC2 Receiver will output
a 720P, 1080P, 4k 30Hz, and a 4k 60hz test pattern.
IR Extension:
IR can be used in two ways:
From Rack (Control System Direct): When using with an AVPro HDBaseT Matrix, simply plug IR Emitter
into the IR Out Port of the SC2 Receiver.
From Remote End: Use the IR Sensor provided with the AC-EX70-SC2-Rs into the IR IN port and send IR
signals back to the AVPro HDBaseT Matrix.
Troubleshooting
•
Verify Power - When power is applied all lights on the top of the device will flash. You can
also press any of the 3 buttons on the side to change settings, the corresponding lights
should change if the unit is powered up.
•
Verify Connections - Make sure all connected cables are properly connected. You can use the
built in Test Pattern Generator to verify signal path from the AC-EX70-SC2-R to the display