Aqua PRO ECO500 Manuale di avvio rapido - Pagina 10

Sfoglia online o scarica il pdf Manuale di avvio rapido per Riscaldatore per piscina Aqua PRO ECO500. Aqua PRO ECO500 12. 50,000 btu heat & cool heat pump pool and spa heater

hour. Use
or
or
to adjust. After adjusting press
seconds later the controller display will be back to the normal mode.
Timer on and off
a. Press
set timer on. When the indicator light is on and the time is flashing, press
set hour. Use
b. Use
or
30 seconds later, the controller display will be back to the normal mode.
c. Press
to set timer off. When the indicator light is on and the time is flashing, press
again to set hour. Use
or
to adjust. After adjusting, press
seconds later, the controller display will be back to the normal mode.
Cancel timer on and off
Press
or
timer indicator light is off and LED shows water temperature, the timer on and off is canceled. 30
seconds later, the controller display will be back to the normal mode.
Testing
1 Inspection before use
A
Check installation of the whole machine and the pipe connections according to the pipe
connecting drawing;
B Check the electric wiring according to the electric wiring diagram; and ground the connection.
C Make sure that the main machine power switch is off
D Check the temperature setting.
E Check the air inlet and outlet.
2 Troubleshooting
A The user must "Start the Pump before the Machine, And Turn off the Heat Pump before the
Pump", or the machine will be damaged.
B
The user should start the pump, check for any leakage of water; and then set suitable
temperature in the thermostat, and then switch on power supply.
to adjust hour. Before the flashing stops, press
or
to adjust. Before the flashing stops, press
to adjust. After adjusting, press
or
to adjust before flashing stop, press
to cancel timer on and off. When the number is flashing, press
and water temperature will be displayed. 30
and water temperature will been seen.
and water temperature will been seen. 30
10
to set minute. Use
again to
to set minute.
to set minute. Use
when