Allied Telesis AT-8748XL Manuale di installazione rapida - Pagina 7

Sfoglia online o scarica il pdf Manuale di installazione rapida per Interruttore Allied Telesis AT-8748XL. Allied Telesis AT-8748XL 10. At-8700xl series switch
Anche per Allied Telesis AT-8748XL: Manuale di installazione rapida (10 pagine)

Stampa la pagina

1. Configuring the Switch

Quick Install Guide

Figure 2: DC Power inlet terminals on an AT-8724XL.

FOR CENTRALIZED DC

POWER CONNECTION,

INSTALL ONLY IN A

RESTRICTED AREA

INPUT

38-75VDC

, 2A

DC Power inlet

C613-04042-01 REV D

The Fault LED should flash for approximately 10 seconds as the switch

runs internal tests. If the LED continues to flash or remains lit, refer to the

AT-8700XL Series Hardware Reference for troubleshooting information.

10. Check that the Power LED on the switch's front panel lights green

If the LED fails to light, refer to the AT-8700XL Series Hardware Reference for

troubleshooting information.

11. Connect the Redundant Power Supply (Optional)

AC models of AT-8700XL Series switches have a Redundant Power Supply

(RPS) connector on their rear panel.

The switch is designed to operate with the AT-RPS8000 RPS, which can be

purchased separately. Contact your authorised Allied Telesyn distributer

or reseller for more information.

12. Connect the data cables

Make sure each cable connection is secure. The switch will now perform

basic Layer 2 switching functions.

Configuring the Switch

Some configuration is necessary if you wish to enable the switch's advanced

switching capabilities. The switch can be configured via the Command Line

Interface (CLI) or Graphical User Interface (GUI).

Using the CLI to configure a switch

Connect a terminal or PC to the Terminal Port (ASYN0)

Using the supplied RS-232 DB9 straight-through cable, connect your

terminal or PC to the RS-232 Terminal Port on the switch's front panel.

Set the communication parameters

Set the communication parameters on your terminal or terminal emulation

program to:

•

Baud rate: 9600

•

Data bits: 8

•

Parity: None

•

Stop bits: 1

•

Flow control: Hardware