Allied Telesis AT-8948 Manuale di installazione rapida - Pagina 5

Sfoglia online o scarica il pdf Manuale di installazione rapida per Interruttore Allied Telesis AT-8948. Allied Telesis AT-8948 13. At-8900 series
Anche per Allied Telesis AT-8948: Scheda tecnica (4 pagine), Scheda tecnica (3 pagine), Scheda tecnica (3 pagine), Scheda tecnica (2 pagine), Scheda tecnica (5 pagine), Panoramica (1 pagine), Come configurare (9 pagine), Opuscolo (8 pagine), Manuale supplementare (6 pagine)

Quick Install Guide

C613-04048-01 REV B

Installing the Switch

This equipment must be earthed.

Follow these steps to install the switch:

Read the safety information

For safety information, see the Safety and Statutory Information booklet. A

copy of this booklet is supplied with each switch, and can also be found on

the Documentation and Tools CD-ROM or at

http://

www.alliedtelesyn.co.nz/support/at8900.

Gather the tools and equipment you will need

If installing a switch with a DC PSU, you will need an appropriate DC

power source, DC supply cable, ring connectors, and a crimp tool.

Choose a suitable site for the switch

Either a 19 inch rack, a flat bench, or a wall.

Unpack the switch

Verify the package contents. If any items are damaged or missing, contact

your sales representative.

Place the switch in its operating location

See the previous "Selecting a Site" section for guidelines on choosing a

suitable location.

To install the switch using the 19 inch rack-mount kit:

•

Ensure the rack has sufficient space for the switch and its associated

cables.

•

Remove the rubber feet from the switch.

•

Screw the brackets to the sides of the switch using the supplied M4

screws (see Figure 1).

•

Fit the adjustable bracket extension onto the rear bracket but do not

fully tighten the nuts. You may need to adjust the position of the

extension bracket to correctly fit the switch into the rack (see Figure 1).

•

Mount the switch in the rack using appropriate rack mounting screws

(not supplied).