AVS RXPRO Manuale di installazione - Pagina 3

Sfoglia online o scarica il pdf Manuale di installazione per Allarme auto AVS RXPRO. AVS RXPRO 10. 4-channel controller

Stampa la pagina

FEATURES OVERVIEW

The following features are programmable for each individual channel. For instructions on how to program each feature

refer to the page number reference.

Feature

Adding new remotes &

deleting remotes

Latched or pulsed output

(factory setting is a 1-

second pulsed output)

Normally open or

normally closed outputs

Timed output

Momentary output

enable

Adding wireless devices

Reed mode enable

Low Battery output from

wireless devices

Re-setting the AVS RXPRO

AVS remote conversion

ENTERING PROGRAMMING MODE

Description

Up to 5 remote controls can be programmed in.

Latched: activating the channel activates the output, activating the channel

again deactivates the output eg. if a light was connected to the output, pressing

the button once would turn the light on, pressing the button again would turn

the light off.

Pulsed: activating the channel will activate the output for only 1 second eg. if a

light was connected to the output, pressing the button would turn the light on

for 1-second, the light will then turn off.

Normally open: output switches to closed when the channel is activated.

Normally closed: output switches to open when the channel is activated eg. use

on channel 4 when a normally closed circuit is required. Channels 1, 2, and 3

have connections for both normally open and normally closed outputs.

Output will activate only for a programmed time when the channel is activated

eg. if a light was connected to the output, pressing the button would turn the

light on for the programmed time, the light will then turn off.

Output is activated while button on remote control is held down and deactivates

when button is released. eg. if a light was connected to the output, while

pressing the button the light would be on, releasing the button will turn the

light off.

Allows wireless detectors to be learnt into the system to trigger one of the

output channels eg. use this for learning in wireless detectors

Output is activated on open and deactivated on close of wireless reed switch.

Use when using wireless reed switches,

Output is activated when a wireless detector learnt into any channel transmits a

low battery signal. i.e. When the battery in the wireless detector goes low, the

output will activate.

Re-setting erases all remotes and detectors and returns programming settings to

the factory default.

Using other AVS remotes with the AVS RXPRO

Disconnect 12VDC power from the unit.

Press and hold button 2 on the remote control.

Reconnect 12VDC Power to the unit.

Release button 2 once the display lights stop scrolling. You are now in

programming mode.

Page

Page 3