DFRobot YDLIDAR GS2 Manuale d'uso - Pagina 4

Sfoglia online o scarica il pdf Manuale d'uso per Microcontrollori DFRobot YDLIDAR GS2. DFRobot YDLIDAR GS2 13. Lidar

Connect the adapter board with GS2 first, then connect the USB cable to the USB port of the

adapter board and the PC. Note that the Type-C interface of the USB cable is connected to the

USB_DATA of the USB adapter board.

The drive current of USB interface of some development platforms or PC is not sufficient. GS2

need to be connected to the auxiliary power supply of +5V, otherwise the lidar will be abnormal.

2.2 Driver Installation

To evaluate and develop the GS2 under Windows, the serial port driver of the USB adapter

board. The USB adapter board need to be installed of this kit adopts CP2102 chip to realize serial

port (UART) to USB signal conversion. Its driver can be downloaded from our official website or

downloaded from the official website of Silicon Labs.

http://cn.silabs.com/products/development-tools/software/usb-to-uart-bridge-vcp-drivers

After unzip the driver package, run the CP2102's Windows driver installation file (exe file

under CP210x_VCP_Windows). Please select the 32-bit version (x86) or 64-bit version (x64)

installation program according to the version of the windows operating system.

GS2 DEVICE CONNECTION

GS2 AUXILIARY POWER SUPPLY

2 / 11