Avsl 952.864UK Manuale d'uso - Pagina 8
Sfoglia online o scarica il pdf Manuale d'uso per Amplificatore Avsl 952.864UK. Avsl 952.864UK 8. Loop amplifiers
Stampa la pagina
Specifications
Model
Power supply
Fuse
Area coverage
Frequency response
Input sensitivity : line
Input sensitivity : mic
Signal to noise ratio
THD
Rack height
Dimensions
Weight
Troubleshooting
No power indicator when
switched on
Peak current indicators are
not showing any signal
Dead spots within
induction loop field
Loop field interfering with
other audio equipment
Siren activated
Peak indicators mainly
showing overload (red)
Loop current is very low
Poor quality audio from
the loop
Disposal: The "Crossed Wheelie Bin" symbol on the product means that the product is classed as Electrical or
Electronic equipment and should not be disposed with other household or commercial waste at the end of its useful life.
The goods must be disposed of according to your local council guidelines.
LA-300 mkII (952.864UK)
110/240Vac, 50/60Hz (IEC)
T1A 250V
300m² max.
50Hz - 5kHz (±3dB)
-6dBu/6k Ohms
-56dBu/2k Ohms
75dB (line), 60dB (mic)
<1%
1U
483 x 235 x 44mm
5.95kg
Check mains is connected and switched on at the socket
Check that the mains fuse is not blown – refer to qualified service personnel
If the fuse is blown, check that the loop contacts were not shorted out
Check input connections are OK and that a signal is present on the input
Check that the loop is intact and connected to the amplifier properly
Increase channel level controls and Loop current if necessary
Check for large metal structures within the architecture close to the loop
Avoid changes in height of the loop cable (running over door frames etc.)
Ensure that the loop cable is twisted between the loop and the loop amplifier
If necessary, form a cancellation loop to avoid affecting other equipment
Ensure that the alarm contacts are not accidentally shorted out.
Loop current or input levels may be too high, decrease the relevant controls
Check that the loop is not shorted or grounded at any point
Increase input signal, channel levels and loop current controls as needed
If there are metal structures nearby, increase metal loss correction level
Use Bass and Treble controls to help improve intelligibility
LA-600 mkII (952.867UK)
T2A 250V
600m² max.
2U
483 x 235 x 88mm
4.22kg
Errors and omissions excepted.
Copyright© 2016. AVSL Group Ltd.
952.864UK, 952.867UK User Manual