DG SATA-IP Istruzioni

Sfoglia online o scarica il pdf Istruzioni per Hardware del computer DG SATA-IP. DG SATA-IP 10.

dg_sata_ip_dev_demo_instruction_at7_en.doc

SATA-IP Device Demo Instruction on AC701

This document describes SATA-IP Device evaluation procedure on AC701 using SATA-IP Device

reference design bit-file. This design support fixed SATA-II speed.

1 Environment Requirement

To run the demo on FPGA development board, please prepare following environment

1. Xilinx Artix-7 FPGA AC701 Evaluation Kit

2. PC which supports SATA-II speed for connecting with SATA-II storage.

3. PC with installing Xilinx programmer software (Vivado) and SATA device connector on PC.

Note: Serial console software such as HyperTerminal or TeraTerm for optional to monitor

status. Set baud rate=115,200 / data=8bit / Non-Parity / Stop=1bit.

4. AB02-CROSSOVER with SATA standard cable to be SATA crossover cable

5. AB10-PATAFMC to be SATA connector of AC701 board

6. AB14-CLKSMA to be clock generator for SATA application

Note: AB02-CROSSOVER, AB10-PATAFMC, and AB14-CLKSMA are provided by Design

Gateway

7. micro USB cable for programming FPGA, connecting between FPGA board and PC

8. (Optional) mini USB cable for Serial console, connecting between FPGA board and PC

17-Jun-21

Figure 1-1 SATA device demo test environment

Rev1.1 17-Jun-21

Page 1