DGF Fabrications N2 Manuale di istruzioni per l'installazione e la manutenzione - Pagina 8

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione e la manutenzione per Camino da interno DGF Fabrications N2. DGF Fabrications N2 14. Gas effect fires (natural gas & lpg) for decorative purposes only

Stampa la pagina

As this is a Special Decorative Gas fire there is no exact pattern for coal layouts, however, the diagrams below

are intended purely as a GUIDE to illustrate the general principles. It is important to leave spaces of approx

15mm - 20mm between the coals to ensure good secondary aeration. Do not overload the fire, it will spoil not

only the appearance of the fire but may also cause the fire to soot. Do not put more than 3 layers of simulated

coals on fire. The small simulated coals can be laid along the front and in the corners of the fire. If different

sized, coals are supplied, start with large coals on base to smaller being at the top and going towards the back is

a typical layout. Depending on the size of the fire it might not be necessary to use all the simulated coals

supplied.

Run the fire for approximately 10 minutes, then if required adjust the simulated coals using suitable non

combustible tool until even flame achieved.

Guide:

Layer 1 (base layer)

Guide:

Layer 2 (middle layer)

Guide:

Layer 3 (top layer)

Units 1-3 Vulcan St, Edward St Industrial Estate, Darlington. DL1 2UL – Tel: 01325 281304; Fax: 01325 481889

Layout For Simulated Coals

DGF Fabrications;