CPS BlackMAX VPC Series Manuale operativo - Pagina 6

Sfoglia online o scarica il pdf Manuale operativo per Pompa dell'acqua CPS BlackMAX VPC Series. CPS BlackMAX VPC Series 8. Cordless vacuum pump

OPERATION

1. Fully charge the 18VDC Li-on battery.

2. The vacuum pump is shipped without oil in the reservoir. Remove the exhaust / oil fill

cap and add oil until it is seen in the middle of the oil sight glass. Re-secure cap.

3. Remove the 1/4" inlet service port cap, turn on the vacuum pump. After 15 seconds,

replace 1/4 cap back on inlet port.

4. Re-check vacuum pump oil level. Add or remove oil if necessary.

To achieve good final vacuum levels, the oil level should be visually seen through sight glass.

CAUTION: DO NOT RUN THIS EQUIPMENT WITH LOW OR NO OIL. RUNNING THIS

EQUIPMENT WITH NO LUBRICATION WILL CAUSE PREMATURE FAILURE.

WARNING: Do not operate on systems under pressure.

1. Install fully charged 18VDC battery onto the

vacuum pump.

-The battery has enough energy to run for

about 45-60 minutes.

2. Check oil level in vacuum pump

3. Connect vacuum pump as shown in

Figure-1.

VPC Single Stage Series Parts

Initial Preparation

VACUUM PUMP IS NOW READY FOR USE.

Damage to the pump may occur.

Figure - 1