Avtech avm420s Manuale rapido

Sfoglia online o scarica il pdf Manuale rapido per Telecamera di sicurezza Avtech avm420s. Avtech avm420s 6.

Stampa la pagina

QUICK GUIDE

Please read instructions thoroughly before operation and retain it for future

reference. Online manual download:

www.surveillance-download.com/user/m521.swf

 Installation

Type 1

Step 1: Uncover the dome camera by loosening the screws on the housing with the supplied wrench.

Step 2: Locate the three holes as illustrated in the right picture. They are where the three supplied screws belong.

Step 3: Mark the locations of the three screw holes on the ceiling or the wall, and drill a hole for each on the

ceiling or the wall.

Step 4: Screw the camera in place.

Step 5: Power up your camera.

Step 6: Check the viewing angle on the PC.

Step 7: Adjust the position and the viewing angle of the camera, if necessary.

Step 8: Replace the dome cover and have the three screws on it tightened.

Note: For clear images, please clear of fingerprints the inner part of the dome cover against the lens.

 Package Content

Before starting to set up your camera, please make sure items below in your box:

 Standard package:

Type 1

or Type 2

Camera

Quick Guide

 Optional accessories

(For Type 1 only)

Screws & Wall Plugs x 3

Step1: Remove the camera base as shown in Figure 1, and disassemble the camera to four parts as shown in Figure 2.

Rotate anti-clockwise

Step2: Locate where you want to install this camera (wall or ceiling), and drill holes on the wall or ceiling for securing

the bracket and routing the cables (if necessary).

Step3: Attach the bracket to the wall (or ceiling), and make sure the cables are routed and arranged properly in the

bracket, as shown in Figure 3.

Step4: Secure the bracket to the wall (or ceiling), as shown in Figure 4.

Where to look

 Cable Overview

Below is an overview of various cables that can be used with the camera. Besides,

it is followed by a table, which offers simple descriptions of cable connection.

Cable

Power cable

RJ45 network cable*

GND

Alarm-in**

Alarm-out**

RESET

Line-in*

Line-out*

Wrench

* For PoE (IEEE802.3af) installation, make sure your network cable has the maximum cable

resistance of 20Ω, such as CAT.5e or CAT.6 cables, to conform to the standard of IEEE802.3af.

** For Type 1 only

Type 2

Remove

Figure 1

Cable routing

Figure 3

621Z

Line-in (blue)**

Line-out (green)**

RJ45 network cable

Alarm-in**

GND

RESET

GND**

Alarm-out**

Power cable

Description

DC12V power supply.

Connect it to a RJ45 cable.

Ground wire

Reserved for external alarm device connection

Remove the insulating coating of wire, and twist it with a ground

wire together to reset default camera

Colored as blue, used to connect to a microphone for audio input.

Colored as green, used to connect to a speaker for audio output.

Camera lens

Base

Part 1

Part 2

Figure 2

Attach to wall (or ceiling)

Figure 4

m532_n332_320_320L_420_quick_V1.0