Avtech AVT2406 Manuale d'uso - Pagina 3

Sfoglia online o scarica il pdf Manuale d'uso per Telecamera di sicurezza Avtech AVT2406. Avtech AVT2406 8. Hd cctv total solution ir

INSTALLATION

Step 1: Loosen the screw as indicated below to move down the camera lens.

Then, fasten the camera to the ceiling or wall where you want to install.

1. loosen a bit

Step 2: Adjust the viewing angle of the camera as indicated below.

Vertical

Step 3: Power on the camera and fine-tune the viewing angle.

For details, please refer to the section, "

WIRE INDICATION FOR ALARM CONNECTION

COLOR

FUNCTION

Red

12V DC

Blue

Digital out

Black

GND

Yellow

Digital in

* Please use with a 12V relay or relay module

This camera is capable of providing power to an external relay or relay module when connecting an alarm

output device. Please note that:

1. When an individual relay is used (instead of using a relay module), it's recommended to add a transient

voltage suppression diode in parallel with the inductive load for protection against electrical spikes and

surges.

2. The external alarm output device could also be power-supplied by the camera if its current request is no

more than 100mA.

3. An external relay can be triggered by using the VDC or by an external power source, depending on the

type of relay you use.

2. Move down a bit

DESCRIPTION

Max. load 100mA

Max. voltage +60VDC / Max. load 100mA

Command ground

CMOS 3.3V logic level

Rotate

FOCAL LENGTH & FOCUS ADJUSTMENT

Horizontal