Avtech DG102A Manuale d'uso - Pagina 3
Sfoglia online o scarica il pdf Manuale d'uso per Telecamera di sicurezza Avtech DG102A. Avtech DG102A 4.
Stampa la pagina
INSTALLATION
1. Turn "Dome Cover" (as shown in Figure 1) counterclockwise to the end and take it off.
2. Mark the positions of one "power and video line hole" and four "screw holes" on the ceiling. (as shown in
Figure 2 & Figure 3).
Drill a hole on the proper position of the ceiling for the power and video line to pass through.
And then screw "base" to the ceiling.
Note: Screws for installation are not supplied within the sales package. Please prepare by yourself and use proper screws.
Suggestions:
a) For safety, please let the power and video line concealed behind the ceiling.
b) If the installation spot doesn't allow the installation personnel to screw power and video line hole on the
ceiling, they could cut the concave edge of "base" to let the power and video line pass through. Be
sure to cover the line to prevent violent attack.
3. Adjust the view angle of the lens(as shown in Figure 3). Then put "dome cover" back to the "base" and
turn clockwise.
Dome Cover
Figure 1
CONNECTION
1. DC12V Input Terminal
Connect the power terminal of the camera to a DC 12V regulated power supply.
NOTE: Please use the correct power adaptor, DC12V (regulated), to operate this unit. The power
tolerance of this unit is DC12V ± 10%. Over maximum DC 12V power input will damage this
unit.
2. Video Output Connector (VIDEO OUT)
Connect the camera video output to the video input of a DVR with 75Ω coaxial cable.
NOTE: To ensure the camera has sufficient protection against moisture, an extra waterproof
measure, such as by using an insulating tape, must be used to cover the power and video
connectors after connection.
CAMERA PARAMETERS
This camera series has its own configuration menu, and either of the two methods below is available to
access the menu based on the camera model you have.
NOTE: The methods below are available only when the camera is used with our brand's HD CCTV
DVR.
Method 1
On the DVR live view, click the channel which connects this camera to display in the full screen mode,
and select
.
Method 2
On the DVR live view, right click to show the DVR main menu, and select "ADVANCED CONFIG"
"DCCS". Then, select the channel which connects this camera, and click "SETUP" to enter the menu of
camera parameters.
www.safemag.ru
* The product image may be different from the actual product.
Figure 2
www.safemag.ru
Power &
Video Line
Hole
4 Screw Holes
Figure 3
Figure 4