Avtech AVT553J Manuale d'uso - Pagina 3

Sfoglia online o scarica il pdf Manuale d'uso per Telecamera IP Avtech AVT553J. Avtech AVT553J 6. Ir bullet camera

INSTALLATION

Step1: Locate where you want to install this camera, and fasten the camera to the ceiling or wall.

NOTE: It's recommended to slightly loosen the screw on the bracket as indicated below to move the

camera down a little bit. It's easier for bracket installation to the ceiling or wall.

Slightly

loosen

Step2: Adjust the viewing angle of the camera, as indicated below.

Horizontal

Slightly

loosen

Step3: Slide the sun shield to the camera, and fasten it with the supplied screw.

Step4: (Optional) Connect to the external alarm device. Please refer to the section "WIRE INDICATION FOR

ALARM CONNECTION" for details.

Step5: Connect the camera to a DVR which supports HD recording, and power on the camera.

NOTE: Please use the correct power adaptor, DC12V (regulated), to operate this unit. The power

tolerance of this unit is DC12V ± 10%. Over maximum DC 12V power input will damage this

unit.

NOTE: A waterproof kit for a coaxial cable could be used to protect the connectors from moisture /

water. Please check "WATERPROOF KIT FOR COAXIAL CABLE" to know how to use it.

Step6: Follow the steps in the next section "ADJUST FOCAL LENGTH & FOCUS" if necessary.

NOTE: In order to make the best performance, please adjust the angle of IR shift up and down within

30 degree respectively, left and right within 15 degree respectively.

Vertical

Slightly

loosen

Rotate

Slightly

loosen