Dell Precision M20 Manuale di servizio - Pagina 10

Sfoglia online o scarica il pdf Manuale di servizio per Computer portatile Dell Precision M20. Dell Precision M20 48. Dell precision m20 service manual

Stampa la pagina
Dell Precision M20 Manuale di servizio
Back to Contents Page
  Microprocessor Module
Dell Precision™ M20 Service Manual
  Removing the Microprocessor Module
  Installing the Microprocessor Module
 Removing the Microprocessor Module
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE:
Do not touch the processor die. Press and hold the microprocessor down on the substrate on which the die is mounted while turning the cam
screw to prevent intermittent contact between the cam screw and microprocessor.
NOTICE:
To avoid damage to the microprocessor, hold the screwdriver so that it is perpendicular to the microprocessor when turning the cam screw.
 
1. Follow the instructions in
"Preparing to Work Inside the
 
2. Remove the
center control
cover.
 
3. Remove the keyboard.
 
4. Remove the
display
assembly.
 
5. Remove the
palm
rest.
NOTICE:
To ensure maximum cooling for the microprocessor, do not touch the heat transfer areas on the microprocessor thermal-cooling assembly. The
oils in your skin reduce the heat transfer capability of the thermal pads.
 
6. Remove the
microprocessor thermal-cooling
NOTICE:
When removing the microprocessor module, pull the module straight up. Be careful not to bend the pins on the microprocessor module.
 
7. To loosen the ZIF socket, use a small flat-blade screwdriver and rotate the ZIF-socket cam screw counterclockwise until you cannot turn the screw any
further.
 
1
microprocessor
2
ZIF-socket cam screw
3
ZIF socket
4
pin-1 corner
    
NOTE:
The ZIF-socket cam screw secures the microprocessor to the system board. Take note of the arrow on the ZIF-socket cam screw.
8. Lift the microprocessor module from the system board.
 Installing the Microprocessor Module
Computer."
assembly.