ENSOTECH SWAVE-E2 Manuale d'uso - Pagina 5

Sfoglia online o scarica il pdf Manuale d'uso per Controllore ENSOTECH SWAVE-E2. ENSOTECH SWAVE-E2 11. Electronic speed controller
Anche per ENSOTECH SWAVE-E2: Manuale (11 pagine)

Stampa la pagina

HARDWARE IS YOUR EXCELLENCE

STEP 1

Turn on your transmitter and connect a fully charged battery to the ESC.

STEP 2

Pull the trigger for full BRAKE/REVERSE and HOLD it in this position.

STEP 3

Turn on the ESC and wait for one short beep – switch-on beep (motor must be connected to the ESC, or there will be

no sounds). After that wait for another beep – calibration beep. (it will be in a second). Do not release the trigger

before calibration beep.

** Beep sound came from the motor movement, there will be no sound without motor.

Full

Reverse

Neutral

point

Pull the trigger to full throttle and wait for TWO short beeps

Neutral

Full

point

Throttle

STEP 5

Release the trigger to neutral position and wait for THREE short beeps

Neutral

Full

point

Throttle

PLEASE NOTE THAT some advanced transmitters have radio channel encoding features. In most cases they use

SSL/SSR open channel encrypting protocol (for details read transmitter's manual) that requires some time to establish

connection between itself and receiver. Swave ESC will be wait for calibration during 2 seconds. If your radio system

requires a comparable time for establishing connection in encrypted mode you should switch this mode off! In other

case some difficulties with calibration may occurs. If you are not certain about the compatibility with your radio system,

please do not open the package. Consult with your seller.

Without properly done calibration the ESC can be damaged. Ensotech is not responsible for compatibility with non-

original equipment.

Unit F, 6 Floor, Cheung Hing Shing Centre, No.23, Sha Tsui Road, Tsuen Wan,

THROTTLE CALIBRATION

BEEP

STEP 4

BEEP

Calibration finish!

WWW.ENSOTECH.LTD

New Territories, Hong Kong