Allied Telesis 86222-10 Note di rilascio - Pagina 5
Sfoglia online o scarica il pdf Note di rilascio per Software Allied Telesis 86222-10. Allied Telesis 86222-10 14. Patch for rapier switches and ar800 series modular switching routers
Stampa la pagina
Patch 86222-10 For Rapier Switches and AR800 Series Modular Switching Routers
Patch 86222-10 for Software Release 2.2.2
C613-10319-00 REV J
PCR: 01197
Module: Q931
Debug messages are no longer generated when a Q.931 Advise of Charge
Notification message is received.
PCR: 01198
Module: TCP
TCP sessions would get stuck in the FINWAIT2 state if the remote host did
not send a FIN message when required. The router now starts a timer when
a TCP session enters the FINWAIT2 state and will automatically close the
session if the timer expires.
PCR: 01199
Module: IPG
The SET IP FILTER command was not correctly handling the ICMPTYPE
and ICMPCODE parameters. This issue has been resolved.
PCR: 01202
Module: DHCP
The router will now accept DHCP messages that are greater than or equal
to 576 bytes in size, and reject any message smaller than 576 bytes. This
operation conforms to RFC 1541.
PCR: 01203
Module: ISAKMP
ISAKMP quick mode exchanges are now committed if any traffic is received
over the newly generated SA. This improves stability in very lossy networks
where the commit message may get lost.
PCR: 01204
Module: ISAKMP
ISAKMP debugging caused a fatal error when the debugging mode was set
to ALL and PFS was enabled. This issue has been resolved.
PCR: 01205
Module: PPP
PPPoE interfaces with IDLE set to ON would not retry active discovery
when more data was received if active discovery had previously failed. This
issue has been resolved.
PCR: 01206
Module: ISAKMP
A memory loss occurred when certificates were used by ISAKMP. This issue
has been resolved.
PCR: 01207
Module: ISAKMP
ISAKMP heartbeats are no longer transmitted if the lower layer interface is
down. This stops ISAKMP heartbeats from bringing up links in dial-up
environments.
PCR: 01209
Module: ISAKMP
In some conditions it was possible for ISAKMP packets to be lost and not
retransmitted. Incoming ISAKMP messages are now validated before
stopping retransmission of the previous message.
PCR: 01211
Module: SWI
The COS_DST bit on ARL for L3 interface should be 0x4 (higher priority) for
CPU ports. This has been corrected.
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
Network affecting: No
5